CLIA Kit for Leptin (LEP)
OB; OBS; Obesity Homolog; Obesity Factor; Obese Protein
- Product No.SCA084Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length2h, 40min
- Detection Range41.2-30,000pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 14.1pg/mL.
- Sample TypeSerum, plasma, saliva, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
For more details, please contact local distributors!US$ 840
For more details, please contact local distributors! US$ 3780
For more details, please contact local distributors! US$ 7140
For more details, please contact local distributors! US$ 58800
For more details, please contact local distributors!
- Packages (Simulation)
- Packages (Simulation)
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the CLIA Kit for Leptin (LEP)
This assay has high sensitivity and excellent specificity for detection of Leptin (LEP).
No significant cross-reactivity or interference between Leptin (LEP) and analogues was observed.
Recovery of the CLIA Kit for Leptin (LEP)
Matrices listed below were spiked with certain level of recombinant Leptin (LEP) and the recovery rates were calculated by comparing the measured value to the expected amount of Leptin (LEP) in samples.
|Matrix||Recovery range (%)||Average(%)|
Precision of the CLIA Kit for Leptin (LEP)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Leptin (LEP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Leptin (LEP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Linearity of the CLIA Kit for Leptin (LEP)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Leptin (LEP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Stability of the CLIA Kit for Leptin (LEP)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the CLIA Kit for Leptin (LEP)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.
Test principle of the CLIA Kit for Leptin (LEP)
The microplate provided in this kit has been pre-coated with an antibody specific to Leptin (LEP). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Leptin (LEP). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Leptin (LEP) level in the sample or standard.;
|Catalog No.||Organism species: Homo sapiens (Human)||Applications (RESEARCH USE ONLY!)|
|APA084Hu01||Active Leptin (LEP)||Cell culture; Activity Assays.|
|RPA084Hu01||Recombinant Leptin (LEP)||Positive Control; Immunogen; SDS-PAGE; WB.|
|PAA084Hu01||Polyclonal Antibody to Leptin (LEP)||WB; IHC; ICC; IP.|
|LAA084Hu71||Biotin-Linked Polyclonal Antibody to Leptin (LEP)||WB; IHC; ICC.|
|LAA084Hu81||FITC-Linked Polyclonal Antibody to Leptin (LEP)||WB; IHC; ICC; IF.|
|MAA084Hu22||Monoclonal Antibody to Leptin (LEP)||WB; IHC; ICC; IP.|
|MAA084Hu21||Monoclonal Antibody to Leptin (LEP)||WB; IHC; ICC; IP.|
|HEA084Hu||High Sensitive ELISA Kit for Leptin (LEP)||Enzyme-linked immunosorbent assay for Antigen Detection.|
|SEA084Hu||ELISA Kit for Leptin (LEP)||Enzyme-linked immunosorbent assay for Antigen Detection.|
|SCA084Hu||CLIA Kit for Leptin (LEP)||Chemiluminescent immunoassay for Antigen Detection.|
|KSA084Hu01||ELISA Kit DIY Materials for Leptin (LEP)||Main materials for "Do It (ELISA Kit) Yourself".|