Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
FIGF; VEGF-D; C-Fos Induced Growth Factor
- Product No.MEA146Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range62.5-4,000pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 24.7pg/mL.
- Sample Typetissue homogenates, cell lysates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 419
For more details, please contact local distributors!US$ 598
For more details, please contact local distributors! US$ 2691
For more details, please contact local distributors! US$ 5083
For more details, please contact local distributors! US$ 41860
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
This assay has high sensitivity and excellent specificity for detection of Mini Samples Vascular Endothelial Growth Factor D (VEGFD).
No significant cross-reactivity or interference between Mini Samples Vascular Endothelial Growth Factor D (VEGFD) and analogues was observed.
Precision of the Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Mini Samples Vascular Endothelial Growth Factor D (VEGFD) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Mini Samples Vascular Endothelial Growth Factor D (VEGFD) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Stability of the Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
1. Prepare all reagents, samples and standards;
2. Add 25µL standard or sample to each well. Incubate 1 hour at 37°C;
3. Aspirate and add 25µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 25µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 25µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 20µL Stop Solution. Read at 450nm immediately.
Test principle of the Mini Samples ELISA Kit for Vascular Endothelial Growth Factor D (VEGFD)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Mini Samples Vascular Endothelial Growth Factor D (VEGFD). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Mini Samples Vascular Endothelial Growth Factor D (VEGFD). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Mini Samples Vascular Endothelial Growth Factor D (VEGFD), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Mini Samples Vascular Endothelial Growth Factor D (VEGFD) in the samples is then determined by comparing the O.D. of the samples to the standard curve.