Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

OSRC; PRB; p105-Rb; pp110; Including Osteosarcoma; Retinoblastoma-associated protein

(Note: Up to 8-plex in one testing reaction)

  • Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc. Packages (Simulation)
  • Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc. Packages (Simulation)
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

This assay has high sensitivity and excellent specificity for detection of Retinoblastoma Protein 1 (RB1) ,etc..
No significant cross-reactivity or interference between Retinoblastoma Protein 1 (RB1) ,etc. and analogues was observed.

Recovery of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

Matrices listed below were spiked with certain level of recombinant Retinoblastoma Protein 1 (RB1) ,etc. and the recovery rates were calculated by comparing the measured value to the expected amount of Retinoblastoma Protein 1 (RB1) ,etc. in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 79-97 89
EDTA plasma(n=5) 78-96 85
heparin plasma(n=5) 95-105 101

Precision of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Retinoblastoma Protein 1 (RB1) ,etc. were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Retinoblastoma Protein 1 (RB1) ,etc. were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Retinoblastoma Protein 1 (RB1) ,etc. and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 97-104% 83-95% 89-104% 87-97%
EDTA plasma(n=5) 93-101% 81-91% 84-93% 90-98%
heparin plasma(n=5) 87-102% 98-105% 78-98% 99-105%

Stability of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

1. Preparation of standards, reagents and samples before the experiment;
2. Add 100μL standard or sample to each well,
    add 10μL magnetic beads, and incubate 90min at 37°C on shaker;
3. Remove liquid on magnetic frame, add 100μL prepared Detection Reagent A. Incubate 60min at 37°C on shaker;
4. Wash plate on magnetic frame for three times;
5. Add 100μL prepared Detection Reagent B, and incubate 30 min at 37°C on shaker;
6. Wash plate on magnetic frame for three times;
7. Add 100μL sheath solution, swirl for 2 minutes, read on the machine.

Test principle of the Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc.

Analyte-specific antibodies are pre-coated onto color-coded microparticles. Microparticles, standards, and samples are pipetted into wells and the immobilized antibodies bind the analytes of interest. After washing away any unbound substances, a biotinylated antibody cocktail specific to the analytes of interest is added to each well. Following a wash to remove any unbound biotinylated antibody, Streptavidin-Phycoerythrin conjugate (Streptavidin-PE), which binds to the biotinylated detection antibodies, is added to each well. A final wash removes unbound Streptavidin-PE and the microparticles are resuspended in buffer and read using the Luminex or Bio-Plex analyzer.The MFI developed is proportional to the concentration of analytes of interest in the sample.

GIVEAWAYS

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB211Hu01 Recombinant Retinoblastoma Protein 1 (RB1) Positive Control; Immunogen; SDS-PAGE; WB.
RPB211Hu02 Recombinant Retinoblastoma Protein 1 (RB1) Positive Control; Immunogen; SDS-PAGE; WB.
PAB211Hu01 Polyclonal Antibody to Retinoblastoma Protein 1 (RB1) WB; IHC; ICC; IP.
PAB211Hu02 Polyclonal Antibody to Retinoblastoma Protein 1 (RB1) WB; IHC; ICC; IP.
LAB211Hu71 Biotin-Linked Polyclonal Antibody to Retinoblastoma Protein 1 (RB1) WB; IHC; ICC.
SEB211Hu ELISA Kit for Retinoblastoma Protein 1 (RB1) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB211Hu Magnetic Luminex Assay Kit for Retinoblastoma Protein 1 (RB1) ,etc. Magnetic Luminex Assay for Antigen Detection.
GUESTBOOK