Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

LAM-A5

(Note: Up to 8-plex in one testing reaction)

  • Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay) Packages (Simulation)
  • Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay) Packages (Simulation)
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

This assay has high sensitivity and excellent specificity for detection of Laminin Alpha 5 (LAMa5).
No significant cross-reactivity or interference between Laminin Alpha 5 (LAMa5) and analogues was observed.

Recovery of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

Matrices listed below were spiked with certain level of recombinant Laminin Alpha 5 (LAMa5) and the recovery rates were calculated by comparing the measured value to the expected amount of Laminin Alpha 5 (LAMa5) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 82-103 98
EDTA plasma(n=5) 79-101 89
heparin plasma(n=5) 97-104 101

Precision of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Laminin Alpha 5 (LAMa5) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Laminin Alpha 5 (LAMa5) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Laminin Alpha 5 (LAMa5) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 78-92% 83-103% 84-94% 82-96%
EDTA plasma(n=5) 94-103% 78-101% 94-101% 96-105%
heparin plasma(n=5) 80-102% 89-97% 93-105% 96-103%

Stability of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

1. Add 200μL analysis buffer solution to each well of the plate for pre-wetting;
2. Preparation of standards, reagents and samples before the experiment;
3. Add 100μL standard or sample to each well, add 10μL magnetic beads, and incubate 120 minutes protect from light at 25°C on shaker;
4. Remove liquid on magnetic frame, add 100μL prepared Detection Reagent A. Incubate 60 minutes protect from light at 25°C on shaker;
5. Remove liquid on magnetic frame, add 100μL prepared Detection Reagent B, and incubate 30 minutes protect from light at 25°C on shaker;
6. Wash plate once on magnetic frame;
7. Add 100μL sheath fluid, swirl for 10 minutes, read on the machine.

Test principle of the Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay)

Anti-Laminin Alpha 5 (LAMa5) antibody was coated on the surface of magnetic beads, to make solid phase carrier. Standard or sample were added to the magnetic beads, respectively, in which Laminin Alpha 5 (LAMa5) was bound to the antibody connected to the solid phase carrier, and then biotinylated anti-Laminin Alpha 5 (LAMa5) antibodies were added. PE-labeled avidin was added. There is a positive correlation between the concentration of Laminin Alpha 5 (LAMa5) in the sample and corresponding value of MFI (Median Fluorescence Intensity).

GIVEAWAYS

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
URPC078Mu01 Recombinant Laminin Alpha 5 (LAMa5) Positive Control; Immunogen; SDS-PAGE; WB.
UPAC078Mu01 Polyclonal Antibody to Laminin Alpha 5 (LAMa5) WB
USEC078Mu ELISA Kit for Laminin Alpha 5 (LAMa5) Enzyme-linked immunosorbent assay for Antigen Detection.
UCMC078Mu Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by CBA (Cytometric Bead Array) FLIA Kit for Antigen Detection.
ULMC078Mu Multiplex Assay Kit for Laminin Alpha 5 (LAMa5) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK