Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
Serum albumin
(Note: Up to 8-plex in one testing reaction)
- Product No.ULMB028Ca
- Organism SpeciesCanis familiaris; Canine (Dog) Same name, Different species.
- Test MethodCompetitive Inhibition
- Assay Length3h
- Detection Range48.83-50000ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 16.277 ng/mL.
- Sample TypeSerum, plasma and other biological fluids
- Download Instruction Manual
- UOM 8Plex 7Plex 6Plex 5Plex 4Plex 3Plex 2Plex1Plex
-
FOB
US$ 174
For more details, please contact local distributors! US$ 181
For more details, please contact local distributors! US$ 191
For more details, please contact local distributors! US$ 204
For more details, please contact local distributors! US$ 218
For more details, please contact local distributors! US$ 238
For more details, please contact local distributors! US$ 268
For more details, please contact local distributors!US$ 335
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
This assay has high sensitivity and excellent specificity for detection of Albumin (ALB).
No significant cross-reactivity or interference between Albumin (ALB) and analogues was observed.
Recovery of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
Matrices listed below were spiked with certain level of recombinant Albumin (ALB) and the recovery rates were calculated by comparing the measured value to the expected amount of Albumin (ALB) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 80-101 | 95 |
| EDTA plasma(n=5) | 97-105 | 101 |
| heparin plasma(n=5) | 85-99 | 94 |
Precision of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Albumin (ALB) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Albumin (ALB) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Albumin (ALB) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 89-102% | 78-89% | 80-93% | 95-102% |
| EDTA plasma(n=5) | 94-101% | 98-105% | 82-97% | 85-92% |
| heparin plasma(n=5) | 79-92% | 80-98% | 85-99% | 81-89% |
Stability of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
1. Add 200μL analysis buffer solution to each well of the plate for pre-wetting;
2. Preparation of standards, reagents and samples before the experiment;
3. Add 50μL standard or sample to each well, add 50μL prepared Detection Reagent A, add 10μL magnetic beads, and incubate 90 minutes protect from light at 25°C on shaker;
4. Remove liquid on magnetic frame, add 100μL prepared Detection Reagent B, and incubate 30 minutes protect from light at 25°C on shaker;
5. Wash plate once on magnetic frame;
6. Add 100μL sheath fluid, swirl for 10 minutes, read on the machine.
Test principle of the Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay)
Anti-Albumin (ALB) antibody was coated on the surface of magnetic beads. A competitive inhibition reaction is launched between biotin labeled Albumin (ALB) and unlabeled Albumin (ALB) (Standards or samples) with the pre-coated antibody specific to Albumin (ALB). PE-labeled avidin was added. The amount of bound PE conjugate is reverse proportional to the concentration of Albumin (ALB) in the sample, the intensity of MFI developed is reverse proportional to the concentration of Albumin (ALB) in the sample.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Canis familiaris; Canine (Dog) | Applications (RESEARCH USE ONLY!) |
| UNPB028Ca01 | Native Albumin (ALB) | Positive Control; Immunogen; SDS-PAGE; WB. |
| URPB028Ca01 | Recombinant Albumin (ALB) | Positive Control; Immunogen; SDS-PAGE; WB. |
| UPAB028Ca01 | Polyclonal Antibody to Albumin (ALB) | WB |
| UPAB028Ca05 | Polyclonal Antibody to Albumin (ALB) | WB |
| UMAB028Ca21 | Monoclonal Antibody to Albumin (ALB) | WB; IHC; ICC; IP. |
| UOEB028Ca | OneStep ELISA Kit for Albumin (ALB) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| UCEB028Ca | ELISA Kit for Albumin (ALB) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| UCMB028Ca | Multiplex Assay Kit for Albumin (ALB) ,etc. by CBA (Cytometric Bead Array) | FLIA Kit for Antigen Detection. |
| ULMB028Ca | Multiplex Assay Kit for Albumin (ALB) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |
| UKSB028Ca11 | ELISA Kit DIY Materials for Albumin (ALB) | Main materials for "Do It (ELISA Kit) Yourself". |