High Sensitive ELISA Kit for Cyclophilin A (CYPA)

PPIA; CyP-A; CYPH; Peptidylprolyl Isomerase A; Peptidyl-Prolyl Isomerase A; Peptidyl-prolyl cis-trans isomerase A; Cyclosporin A-binding protein

  • High Sensitive ELISA Kit for Cyclophilin A (CYPA) Packages (Simulation)
  • High Sensitive ELISA Kit for Cyclophilin A (CYPA) Packages (Simulation)
  • High Sensitive ELISA Kit for Cyclophilin A (CYPA) Results demonstration
  • HEA979Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

This assay has high sensitivity and excellent specificity for detection of High Sensitive Cyclophilin A (CYPA).
No significant cross-reactivity or interference between High Sensitive Cyclophilin A (CYPA) and analogues was observed.

Recovery of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

Matrices listed below were spiked with certain level of recombinant High Sensitive Cyclophilin A (CYPA) and the recovery rates were calculated by comparing the measured value to the expected amount of High Sensitive Cyclophilin A (CYPA) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 78-92 88
EDTA plasma(n=5) 85-101 95
heparin plasma(n=5) 89-102 98

Precision of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level High Sensitive Cyclophilin A (CYPA) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level High Sensitive Cyclophilin A (CYPA) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of High Sensitive Cyclophilin A (CYPA) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 97-105% 87-98% 97-105% 80-101%
EDTA plasma(n=5) 88-96% 79-98% 92-105% 79-101%
heparin plasma(n=5) 95-102% 84-104% 95-102% 98-105%

Stability of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the High Sensitive ELISA Kit for Cyclophilin A (CYPA)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to High Sensitive Cyclophilin A (CYPA). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to High Sensitive Cyclophilin A (CYPA). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain High Sensitive Cyclophilin A (CYPA), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of High Sensitive Cyclophilin A (CYPA) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPA979Mu01 Recombinant Cyclophilin A (CYPA) Positive Control; Immunogen; SDS-PAGE; WB.
RPA979Mu02 Recombinant Cyclophilin A (CYPA) Positive Control; Immunogen; SDS-PAGE; WB.
PAA979Mu02 Polyclonal Antibody to Cyclophilin A (CYPA) WB; IHC; ICC; IP.
PAA979Mu01 Polyclonal Antibody to Cyclophilin A (CYPA) WB; IHC; ICC; IP.
FAA979Mu01 Anti-Cyclophilin A (CYPA) Polyclonal Antibody Flow cytometry.
LAA979Mu81 FITC-Linked Polyclonal Antibody to Cyclophilin A (CYPA) WB; IHC; ICC; IF.
LAA979Mu71 Biotin-Linked Polyclonal Antibody to Cyclophilin A (CYPA) WB; IHC; ICC.
MAA979Mu21 Monoclonal Antibody to Cyclophilin A (CYPA) WB; IHC; ICC; IP.
MAA979Mu22 Monoclonal Antibody to Cyclophilin A (CYPA) WB; IHC
HEA979Mu High Sensitive ELISA Kit for Cyclophilin A (CYPA) Enzyme-linked immunosorbent assay for Antigen Detection.
SEA979Mu ELISA Kit for Cyclophilin A (CYPA) Enzyme-linked immunosorbent assay for Antigen Detection.
LMA979Mu Multiplex Assay Kit for Cyclophilin A (CYPA) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
PSA979Mu01 Antibody Pair for Cyclophilin A (CYPA) ELISA; CLIA; ELISPOT; Luminex; Immunochromatography and other Immunoassays.
KSA979Mu01 ELISA Kit DIY Materials for Cyclophilin A (CYPA) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK