ELISA Kit for Scleraxis Homolog B (SCXB)

SCX; BHLHA41; BHLHA48; SCXA; Basic Helix-Loop-Helix Transcription Factor Scleraxis; Class A basic helix-loop-helix protein 48

  • ELISA Kit for Scleraxis Homolog B (SCXB) Packages (Simulation)
  • ELISA Kit for Scleraxis Homolog B (SCXB) Packages (Simulation)
  • ELISA Kit for Scleraxis Homolog B (SCXB) Results demonstration
  • SET801Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Scleraxis Homolog B (SCXB)

This assay has high sensitivity and excellent specificity for detection of Scleraxis Homolog B (SCXB).
No significant cross-reactivity or interference between Scleraxis Homolog B (SCXB) and analogues was observed.

Precision of the ELISA Kit for Scleraxis Homolog B (SCXB)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Scleraxis Homolog B (SCXB) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Scleraxis Homolog B (SCXB) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the ELISA Kit for Scleraxis Homolog B (SCXB)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Scleraxis Homolog B (SCXB)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Scleraxis Homolog B (SCXB)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Scleraxis Homolog B (SCXB). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Scleraxis Homolog B (SCXB). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Scleraxis Homolog B (SCXB), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Scleraxis Homolog B (SCXB) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPT801Hu01 Recombinant Scleraxis Homolog B (SCXB) Positive Control; Immunogen; SDS-PAGE; WB.
PAT801Hu01 Polyclonal Antibody to Scleraxis Homolog B (SCXB) WB; IHC; ICC; IP.
MAT801Hu21 Monoclonal Antibody to Scleraxis Homolog B (SCXB) WB; IHC; ICC; IP.
SET801Hu ELISA Kit for Scleraxis Homolog B (SCXB) Enzyme-linked immunosorbent assay for Antigen Detection.
LMT801Hu Multiplex Assay Kit for Scleraxis Homolog B (SCXB) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK