ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

ZMIZ5; Zinc Finger,MIZ-Type Containing 5; E3 SUMO-protein ligase PIAS3

  • ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3) Packages (Simulation)
  • ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3) Packages (Simulation)
  • ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3) Results demonstration
  • SEE590Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

This assay has high sensitivity and excellent specificity for detection of Protein Inhibitor Of Activated STAT 3 (PIAS3).
No significant cross-reactivity or interference between Protein Inhibitor Of Activated STAT 3 (PIAS3) and analogues was observed.

Recovery of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

Matrices listed below were spiked with certain level of recombinant Protein Inhibitor Of Activated STAT 3 (PIAS3) and the recovery rates were calculated by comparing the measured value to the expected amount of Protein Inhibitor Of Activated STAT 3 (PIAS3) in samples.

Matrix Recovery range (%) Average(%)
90-101 96

Precision of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Protein Inhibitor Of Activated STAT 3 (PIAS3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Protein Inhibitor Of Activated STAT 3 (PIAS3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Protein Inhibitor Of Activated STAT 3 (PIAS3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
80-104% 97-105% 92-101% 80-105%

Stability of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Protein Inhibitor Of Activated STAT 3 (PIAS3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Protein Inhibitor Of Activated STAT 3 (PIAS3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Protein Inhibitor Of Activated STAT 3 (PIAS3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Protein Inhibitor Of Activated STAT 3 (PIAS3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPE590Hu01 Recombinant Protein Inhibitor Of Activated STAT 3 (PIAS3) Positive Control; Immunogen; SDS-PAGE; WB.
PAE590Hu01 Polyclonal Antibody to Protein Inhibitor Of Activated STAT 3 (PIAS3) WB; IHC; ICC; IP.
MAE590Hu21 Monoclonal Antibody to Protein Inhibitor Of Activated STAT 3 (PIAS3) WB; IHC; ICC; IP.
SEE590Hu ELISA Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3) Enzyme-linked immunosorbent assay for Antigen Detection.
LME590Hu Multiplex Assay Kit for Protein Inhibitor Of Activated STAT 3 (PIAS3) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK