ELISA Kit for Peptidase Inhibitor 16 (PI16)

MSMBBP; CRISP9; PSPBP; Microseminoprotein, Beta-Binding Protein; Protease Inhibitor 16; PSP94-binding protein; Cysteine-rich secretory protein 9

  • ELISA Kit for Peptidase Inhibitor 16 (PI16) Packages (Simulation)
  • ELISA Kit for Peptidase Inhibitor 16 (PI16) Packages (Simulation)
  • ELISA Kit for Peptidase Inhibitor 16 (PI16) Results demonstration
  • SEQ943Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

This assay has high sensitivity and excellent specificity for detection of Peptidase Inhibitor 16 (PI16).
No significant cross-reactivity or interference between Peptidase Inhibitor 16 (PI16) and analogues was observed.

Recovery of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

Matrices listed below were spiked with certain level of recombinant Peptidase Inhibitor 16 (PI16) and the recovery rates were calculated by comparing the measured value to the expected amount of Peptidase Inhibitor 16 (PI16) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 80-93 84
EDTA plasma(n=5) 98-105 102
heparin plasma(n=5) 80-104 96

Precision of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Peptidase Inhibitor 16 (PI16) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Peptidase Inhibitor 16 (PI16) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Peptidase Inhibitor 16 (PI16) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 83-97% 83-101% 90-103% 79-103%
EDTA plasma(n=5) 86-99% 92-101% 91-105% 93-101%
heparin plasma(n=5) 87-101% 79-92% 78-99% 85-97%

Stability of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Peptidase Inhibitor 16 (PI16)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Peptidase Inhibitor 16 (PI16). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Peptidase Inhibitor 16 (PI16). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Peptidase Inhibitor 16 (PI16), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Peptidase Inhibitor 16 (PI16) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPQ943Hu01 Recombinant Peptidase Inhibitor 16 (PI16) Positive Control; Immunogen; SDS-PAGE; WB.
PAQ943Hu01 Polyclonal Antibody to Peptidase Inhibitor 16 (PI16) WB; IHC; ICC; IP.
FAQ943Hu01 Anti-Peptidase Inhibitor 16 (PI16) Polyclonal Antibody Flow cytometry.
LAQ943Hu71 Biotin-Linked Polyclonal Antibody to Peptidase Inhibitor 16 (PI16) WB; IHC; ICC.
MAQ943Hu21 Monoclonal Antibody to Peptidase Inhibitor 16 (PI16) WB; IHC; ICC; IP.
MAQ943Hu22 Monoclonal Antibody to Peptidase Inhibitor 16 (PI16) WB; IHC; ICC; IP.
MAQ943Hu23 Monoclonal Antibody to Peptidase Inhibitor 16 (PI16) WB; IHC; ICC; IP.
SEQ943Hu ELISA Kit for Peptidase Inhibitor 16 (PI16) Enzyme-linked immunosorbent assay for Antigen Detection.
LMQ943Hu Multiplex Assay Kit for Peptidase Inhibitor 16 (PI16) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK