ELISA Kit for Kynurenine (KYN)

Benzenebutanoic acid, α,2-diamino-γ-oxo-Alanine, 3-anthraniloyl-α,2-Diamino-γ-oxobenzenebutanoic acid, 3-Anthraniloylalanine

  • ELISA Kit for Kynurenine (KYN) Packages (Simulation)
  • ELISA Kit for Kynurenine (KYN) Packages (Simulation)
  • ELISA Kit for Kynurenine (KYN) Results demonstration
  • CEX300Ge.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Kynurenine (KYN)

This assay has high sensitivity and excellent specificity for detection of Kynurenine (KYN).
No significant cross-reactivity or interference between Kynurenine (KYN) and analogues was observed.

Recovery of the ELISA Kit for Kynurenine (KYN)

Matrices listed below were spiked with certain level of Kynurenine (KYN) and the recovery rates were calculated by comparing the measured value to the expected amount of Kynurenine (KYN) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 95-102 99
EDTA plasma(n=5) 98-105 101
heparin plasma(n=5) 88-95 91

Precision of the ELISA Kit for Kynurenine (KYN)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Kynurenine (KYN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Kynurenine (KYN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Kynurenine (KYN)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Kynurenine (KYN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 80-105% 86-104% 94-103% 80-105%
EDTA plasma(n=5) 80-95% 88-101% 97-104% 99-105%
heparin plasma(n=5) 98-105% 83-98% 91-105% 84-101%

Stability of the ELISA Kit for Kynurenine (KYN)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Kynurenine (KYN)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.

Test principle of the ELISA Kit for Kynurenine (KYN)

This assay employs the competitive inhibition enzyme immunoassay technique. An antibody specific to KYN has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled KYN and unlabeled KYN (Standards or samples) with the pre-coated antibody specific to KYN. After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of KYN in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of KYN in the sample.

Related products

Catalog No. Organism species: Pan-species (General) Applications (RESEARCH USE ONLY!)
UCEX300Ge ELISA Kit for Kynurenine (KYN) Enzyme-linked immunosorbent assay for Antigen Detection.
ULMX300Ge Multiplex Assay Kit for Kynurenine (KYN) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK