ELISA Kit for Myeloperoxidase (MPO)

  • ELISA Kit for Myeloperoxidase (MPO) Packages (Simulation)
  • ELISA Kit for Myeloperoxidase (MPO) Packages (Simulation)
  • ELISA Kit for Myeloperoxidase (MPO) Results demonstration
  • SEA601Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Myeloperoxidase (MPO)

This assay has high sensitivity and excellent specificity for detection of Myeloperoxidase (MPO).
No significant cross-reactivity or interference between Myeloperoxidase (MPO) and analogues was observed.

Recovery of the ELISA Kit for Myeloperoxidase (MPO)

Matrices listed below were spiked with certain level of recombinant Myeloperoxidase (MPO) and the recovery rates were calculated by comparing the measured value to the expected amount of Myeloperoxidase (MPO) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 95-102 98
EDTA plasma(n=5) 79-91 85
heparin plasma(n=5) 81-89 84

Precision of the ELISA Kit for Myeloperoxidase (MPO)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Myeloperoxidase (MPO) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Myeloperoxidase (MPO) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Myeloperoxidase (MPO)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Myeloperoxidase (MPO) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 98-105% 87-97% 87-104% 88-105%
EDTA plasma(n=5) 90-98% 94-101% 85-104% 91-98%
heparin plasma(n=5) 98-105% 85-97% 93-101% 91-99%

Stability of the ELISA Kit for Myeloperoxidase (MPO)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Myeloperoxidase (MPO)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Myeloperoxidase (MPO)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Myeloperoxidase (MPO). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Myeloperoxidase (MPO). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Myeloperoxidase (MPO), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Myeloperoxidase (MPO) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA601Hu01 Recombinant Myeloperoxidase (MPO) Positive Control; Immunogen; SDS-PAGE; WB.
EPA601Hu61 Eukaryotic Myeloperoxidase (MPO) Positive Control; Immunogen; SDS-PAGE; WB.
APA601Hu61 Active Myeloperoxidase (MPO) Cell culture; Activity Assays.
RPA601Hu02 Recombinant Myeloperoxidase (MPO) Positive Control; Immunogen; SDS-PAGE; WB.
APA601Hu02 Active Myeloperoxidase (MPO) Cell culture; Activity Assays.
PAA601Hu01 Polyclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC; IP.
LAA601Hu71 Biotin-Linked Polyclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC.
MAA601Hu23 Monoclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC; IP.
MAA601Hu21 Monoclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC; IP.
MAA601Hu22 Monoclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC; IP.
MAA601Hu24 Monoclonal Antibody to Myeloperoxidase (MPO) WB; IHC; ICC; IP.
SEA601Hu ELISA Kit for Myeloperoxidase (MPO) Enzyme-linked immunosorbent assay for Antigen Detection.
AEA601Hu ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO) Enzyme-linked immunosorbent assay for Antibody Detection.
SCA601Hu CLIA Kit for Myeloperoxidase (MPO) Chemiluminescent immunoassay for Antigen Detection.
LMA601Hu Multiplex Assay Kit for Myeloperoxidase (MPO) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA601Hu01 ELISA Kit DIY Materials for Myeloperoxidase (MPO) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK