ELISA Kit for Low Density Lipoprotein (LDL)
- Product No.SEB107Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range7.8-500ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 3.7ng/mL.
- Sample Typeserum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 280
For more details, please contact local distributors!US$ 400
For more details, please contact local distributors! US$ 1800
For more details, please contact local distributors! US$ 3400
For more details, please contact local distributors! US$ 28000
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Low Density Lipoprotein (LDL)
This assay has high sensitivity and excellent specificity for detection of Low Density Lipoprotein (LDL).
No significant cross-reactivity or interference between Low Density Lipoprotein (LDL) and analogues was observed.
Recovery of the ELISA Kit for Low Density Lipoprotein (LDL)
Matrices listed below were spiked with certain level of recombinant Low Density Lipoprotein (LDL) and the recovery rates were calculated by comparing the measured value to the expected amount of Low Density Lipoprotein (LDL) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 90-98 | 94 |
| EDTA plasma(n=5) | 89-96 | 92 |
| heparin plasma(n=5) | 81-98 | 84 |
Precision of the ELISA Kit for Low Density Lipoprotein (LDL)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Low Density Lipoprotein (LDL) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Low Density Lipoprotein (LDL) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Low Density Lipoprotein (LDL)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Low Density Lipoprotein (LDL) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 96-103% | 90-101% | 80-95% | 86-102% |
| EDTA plasma(n=5) | 88-95% | 78-92% | 88-99% | 87-104% |
| heparin plasma(n=5) | 94-102% | 85-99% | 82-97% | 78-99% |
Stability of the ELISA Kit for Low Density Lipoprotein (LDL)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Low Density Lipoprotein (LDL)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Low Density Lipoprotein (LDL)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Low Density Lipoprotein (LDL). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Low Density Lipoprotein (LDL). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Low Density Lipoprotein (LDL), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Low Density Lipoprotein (LDL) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Homo sapiens (Human) | Applications (RESEARCH USE ONLY!) |
| NPB107Hu01 | Native Low Density Lipoprotein (LDL) | Positive Control; Immunogen; SDS-PAGE; WB. |
| PAB107Hu01 | Polyclonal Antibody to Low Density Lipoprotein (LDL) | WB; IHC; ICC; IP. |
| LAB107Hu71 | Biotin-Linked Polyclonal Antibody to Low Density Lipoprotein (LDL) | WB; IHC; ICC. |
| HEB107Hu | High Sensitive ELISA Kit for Low Density Lipoprotein (LDL) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| SEB107Hu | ELISA Kit for Low Density Lipoprotein (LDL) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| SCB107Hu | CLIA Kit for Low Density Lipoprotein (LDL) | Chemiluminescent immunoassay for Antigen Detection. |
| LMB107Hu | Multiplex Assay Kit for Low Density Lipoprotein (LDL) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |
| KSB107Hu01 | ELISA Kit DIY Materials for Low Density Lipoprotein (LDL) | Main materials for "Do It (ELISA Kit) Yourself". |