ELISA Kit for Factor Related Apoptosis Ligand (FASL)

CD178; CD95L; CD95-L; FASLG; FASLG; APT1LG1; APT1-LG1; TNFSF6; Fas Antigen Ligand; TNF Superfamily Member 6; Tumor Necrosis Factor(ligand)Superfamily,Member 6

  • ELISA Kit for Factor Related Apoptosis Ligand (FASL) Packages (Simulation)
  • ELISA Kit for Factor Related Apoptosis Ligand (FASL) Packages (Simulation)
  • ELISA Kit for Factor Related Apoptosis Ligand (FASL) Results demonstration
  • SEA031Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

This assay has high sensitivity and excellent specificity for detection of Factor Related Apoptosis Ligand (FASL).
No significant cross-reactivity or interference between Factor Related Apoptosis Ligand (FASL) and analogues was observed.

Recovery of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

Matrices listed below were spiked with certain level of recombinant Factor Related Apoptosis Ligand (FASL) and the recovery rates were calculated by comparing the measured value to the expected amount of Factor Related Apoptosis Ligand (FASL) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 90-102 99
EDTA plasma(n=5) 88-104 93
heparin plasma(n=5) 78-105 99

Precision of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Factor Related Apoptosis Ligand (FASL) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Factor Related Apoptosis Ligand (FASL) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Factor Related Apoptosis Ligand (FASL) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 89-99% 84-96% 97-105% 92-105%
EDTA plasma(n=5) 79-102% 80-97% 78-93% 94-102%
heparin plasma(n=5) 96-105% 81-103% 83-101% 86-95%

Stability of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Factor Related Apoptosis Ligand (FASL)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Factor Related Apoptosis Ligand (FASL). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Factor Related Apoptosis Ligand (FASL). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Factor Related Apoptosis Ligand (FASL), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Factor Related Apoptosis Ligand (FASL) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA031Hu01 Recombinant Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
RPA031Hu02 Recombinant Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
APA031Hu01 Active Factor Related Apoptosis Ligand (FASL) Cell culture; Activity Assays.
PAA031Hu02 Polyclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC; IP.
PAA031Hu01 Polyclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC; IP.
FAA031Hu01 Anti-Factor Related Apoptosis Ligand (FASL) Polyclonal Antibody Flow cytometry.
LAA031Hu71 Biotin-Linked Polyclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC.
MAA031Hu22 Monoclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC; IP.
SEA031Hu ELISA Kit for Factor Related Apoptosis Ligand (FASL) Enzyme-linked immunosorbent assay for Antigen Detection.
LMA031Hu Multiplex Assay Kit for Factor Related Apoptosis Ligand (FASL) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA031Hu01 ELISA Kit DIY Materials for Factor Related Apoptosis Ligand (FASL) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK