ELISA Kit for Complement Component 3 (C3)

ASP; CPAMD1; Complement Protein C3; C3 and PZP-like alpha-2-macroglobulin domain-containing protein 1; C3a anaphylatoxin; Acylation stimulating protein

  • ELISA Kit for Complement Component 3 (C3) Packages (Simulation)
  • ELISA Kit for Complement Component 3 (C3) Packages (Simulation)
  • ELISA Kit for Complement Component 3 (C3) Results demonstration
  • SEA861Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Complement Component 3 (C3)

This assay has high sensitivity and excellent specificity for detection of Complement Component 3 (C3).
No significant cross-reactivity or interference between Complement Component 3 (C3) and analogues was observed.

Recovery of the ELISA Kit for Complement Component 3 (C3)

Matrices listed below were spiked with certain level of recombinant Complement Component 3 (C3) and the recovery rates were calculated by comparing the measured value to the expected amount of Complement Component 3 (C3) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 78-92 88
EDTA plasma(n=5) 87-102 92
heparin plasma(n=5) 93-101 97

Precision of the ELISA Kit for Complement Component 3 (C3)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Complement Component 3 (C3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Complement Component 3 (C3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Complement Component 3 (C3)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Complement Component 3 (C3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 90-98% 81-98% 91-98% 95-105%
EDTA plasma(n=5) 91-105% 89-98% 99-105% 88-102%
heparin plasma(n=5) 79-93% 89-96% 89-96% 78-92%

Stability of the ELISA Kit for Complement Component 3 (C3)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Complement Component 3 (C3)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Complement Component 3 (C3)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Complement Component 3 (C3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Complement Component 3 (C3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Complement Component 3 (C3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Complement Component 3 (C3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA861Hu01 Recombinant Complement Component 3 (C3) Positive Control; Immunogen; SDS-PAGE; WB.
APA861Hu01 Active Complement Component 3 (C3) Cell culture; Activity Assays.
PAA861Hu01 Polyclonal Antibody to Complement Component 3 (C3) WB; IHC; ICC; IP; FCM
LAA861Hu81 FITC-Linked Polyclonal Antibody to Complement Component 3 (C3) WB; IHC; ICC; IF.
LAA861Hu71 Biotin-Linked Polyclonal Antibody to Complement Component 3 (C3) WB; IHC; ICC.
MAA861Hu22 Monoclonal Antibody to Complement Component 3 (C3) WB; IHC; ICC; IP.
SEA861Hu ELISA Kit for Complement Component 3 (C3) Enzyme-linked immunosorbent assay for Antigen Detection.
LMA861Hu Multiplex Assay Kit for Complement Component 3 (C3) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK