ELISA Kit for Glutathione S Transferase (GST)

GST-Tag

  • ELISA Kit for Glutathione S Transferase (GST) Packages (Simulation)
  • ELISA Kit for Glutathione S Transferase (GST) Packages (Simulation)
  • ELISA Kit for Glutathione S Transferase (GST) Results demonstration
  • SEX158Ge.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Glutathione S Transferase (GST)

This assay has high sensitivity and excellent specificity for detection of Glutathione S Transferase (GST).
No significant cross-reactivity or interference between Glutathione S Transferase (GST) and analogues was observed.

Precision of the ELISA Kit for Glutathione S Transferase (GST)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Glutathione S Transferase (GST) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Glutathione S Transferase (GST) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the ELISA Kit for Glutathione S Transferase (GST)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Glutathione S Transferase (GST)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Glutathione S Transferase (GST)

The microtiter plate provided in this kit has been pre-coated with an antibody specific to GST. Standards or samples are then added to the appropriate microtiter plate wells with a Horseradish Peroxidase (HRP)-conjugated antibody specific to GST. After TMB substrate solution is added, those wells that contain GST will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of GST in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Pan-species (General) Applications (RESEARCH USE ONLY!)
RPX158Ge01 Recombinant Glutathione S Transferase (GST) Positive Control; Immunogen; SDS-PAGE; WB.
RPX158Ge02 Recombinant Glutathione S Transferase (GST) Positive Control; Immunogen; SDS-PAGE; WB.
TAX158Ge01 Anti-Glutathione S Transferase (GST) Tag Polyclonal Antibody WB; Dot Blot; IP.
MAX158Ge22 Monoclonal Antibody to Glutathione S Transferase (GST) WB; IHC; ICC; IP.
MAX158Ge21 Monoclonal Antibody to Glutathione S Transferase (GST) WB; IHC; ICC; IP.
TAX158Ge22 Anti-Glutathione S Transferase (GST) Tag Monoclonal Antibody WB; Dot Blot; IP.
SEX158Ge ELISA Kit for Glutathione S Transferase (GST) Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK