ELISA Kit for Early Endosome Antigen 1 (EEA1)

ZFYVE2; Endosome-associated protein p162; Zinc finger FYVE domain-containing protein 2

  • ELISA Kit for Early Endosome Antigen 1 (EEA1) Packages (Simulation)
  • ELISA Kit for Early Endosome Antigen 1 (EEA1) Packages (Simulation)
  • ELISA Kit for Early Endosome Antigen 1 (EEA1) Results demonstration
  • SEJ176Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Early Endosome Antigen 1 (EEA1)

This assay has high sensitivity and excellent specificity for detection of Early Endosome Antigen 1 (EEA1).
No significant cross-reactivity or interference between Early Endosome Antigen 1 (EEA1) and analogues was observed.

Precision of the ELISA Kit for Early Endosome Antigen 1 (EEA1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Early Endosome Antigen 1 (EEA1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Early Endosome Antigen 1 (EEA1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the ELISA Kit for Early Endosome Antigen 1 (EEA1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Early Endosome Antigen 1 (EEA1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Early Endosome Antigen 1 (EEA1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Early Endosome Antigen 1 (EEA1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Early Endosome Antigen 1 (EEA1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Early Endosome Antigen 1 (EEA1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Early Endosome Antigen 1 (EEA1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPJ176Hu01 Recombinant Early Endosome Antigen 1 (EEA1) Positive Control; Immunogen; SDS-PAGE; WB.
PAJ176Hu01 Polyclonal Antibody to Early Endosome Antigen 1 (EEA1) WB; IHC; ICC; IP.
MAJ176Hu21 Monoclonal Antibody to Early Endosome Antigen 1 (EEA1) WB; IHC; ICC; IP.
SEJ176Hu ELISA Kit for Early Endosome Antigen 1 (EEA1) Enzyme-linked immunosorbent assay for Antigen Detection.
LMJ176Hu Multiplex Assay Kit for Early Endosome Antigen 1 (EEA1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK