ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

Sodium pump subunit alpha-1; Na(+)/K(+) ATPase alpha-1 subunit; Sodium/potassium-transporting ATPase subunit alpha-1

  • ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) Packages (Simulation)
  • ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) Packages (Simulation)
  • ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) Results demonstration
  • SEG369Mi.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

This assay has high sensitivity for detection of ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1).
100% cross-reactivity of ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) was observed among Human, Mouse, Rat, Porcine.

Recovery of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

Matrices listed below were spiked with certain level of recombinant ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) and the recovery rates were calculated by comparing the measured value to the expected amount of ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 80-90 87
EDTA plasma(n=5) 85-93 88
heparin plasma(n=5) 85-97 88

Precision of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-96% 88-101% 89-103% 79-103%
EDTA plasma(n=5) 88-96% 86-94% 89-103% 80-98%
heparin plasma(n=5) 95-105% 87-95% 78-92% 82-97%

Stability of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human), Mus musculus (Mouse), Rattus norvegicus (Rat), Sus scrofa; Porcine (Pig) Applications (RESEARCH USE ONLY!)
RPG369Mi01 Recombinant ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) Positive Control; Immunogen; SDS-PAGE; WB.
PAG369Mi01 Polyclonal Antibody to ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) WB; IHC; ICC; IP.
SEG369Mi ELISA Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) Enzyme-linked immunosorbent assay for Antigen Detection.
LMG369Mi Multiplex Assay Kit for ATPase, Na+/K+ Transporting Alpha 1 Polypeptide (ATP1a1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK