CLIA Kit for Plasminogen (Plg)

PL; Plasmin; Activation peptide; Angiostatin

  • CLIA Kit for Plasminogen (Plg) Packages (Simulation)
  • CLIA Kit for Plasminogen (Plg) Packages (Simulation)
  • CLIA Kit for Plasminogen (Plg) Results demonstration
  • SCB236Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Plasminogen (Plg)

This assay has high sensitivity and excellent specificity for detection of Plasminogen (Plg).
No significant cross-reactivity or interference between Plasminogen (Plg) and analogues was observed.

Recovery of the CLIA Kit for Plasminogen (Plg)

Matrices listed below were spiked with certain level of recombinant Plasminogen (Plg) and the recovery rates were calculated by comparing the measured value to the expected amount of Plasminogen (Plg) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 85-93 88
EDTA plasma(n=5) 95-105 101
heparin plasma(n=5) 91-105 101

Precision of the CLIA Kit for Plasminogen (Plg)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Plasminogen (Plg) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Plasminogen (Plg) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Plasminogen (Plg)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Plasminogen (Plg) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 88-104% 80-101% 86-101% 85-96%
EDTA plasma(n=5) 86-94% 80-101% 78-101% 95-104%
heparin plasma(n=5) 79-94% 94-102% 90-97% 80-102%

Stability of the CLIA Kit for Plasminogen (Plg)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Plasminogen (Plg)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Plasminogen (Plg)

The microplate provided in this kit has been pre-coated with an antibody specific to Plasminogen (Plg). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Plasminogen (Plg). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Plasminogen (Plg) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
UNPB236Hu01 Native Plasminogen (Plg) Positive Control; Immunogen; SDS-PAGE; WB.
URPB236Hu03 Recombinant Plasminogen (Plg) Positive Control; Immunogen; SDS-PAGE; WB.
URPB236Hu01 Recombinant Plasminogen (Plg) Positive Control; Immunogen; SDS-PAGE; WB.
UAPB236Hu01 Active Plasminogen (Plg) Cell culture; Activity Assays.
UEPB236Hu51 Eukaryotic Plasminogen (Plg) Positive Control; Immunogen; SDS-PAGE; WB.
UAPB236Hu51 Active Plasminogen (Plg) Cell culture; Activity Assays.
URPB236Hu02 Recombinant Plasminogen (Plg) Positive Control; Immunogen; SDS-PAGE; WB.
UPAB236Hu07 Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UPAB236Hu01 Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UPAB236Hu05 Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UPAB236Hu02 Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UFAB236Hu01 Anti-Plasminogen (Plg) Polyclonal Antibody FCM
ULAB236Hu81 FITC-Linked Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IF.
ULAB236Hu71 Biotin-Linked Polyclonal Antibody to Plasminogen (Plg) WB; IHC; ICC.
UMAB236Hu24 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu25 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu26 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu22 Monoclonal Antibody to Plasminogen (Plg) WB
UMAB236Hu28 Monoclonal Antibody to Plasminogen (Plg) IHC
UMAB236Hu21 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu23 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu27 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UMAB236Hu29 Monoclonal Antibody to Plasminogen (Plg) WB; IHC; ICC; IP.
UFAB236Hu02 Anti-Plasminogen (Plg) Monoclonal Antibody FCM
UFAB236Hu04 Anti-Plasminogen (Plg) Monoclonal Antibody FCM
UFAB236Hu06 Anti-Plasminogen (Plg) Monoclonal Antibody FCM
USEB236Hu ELISA Kit for Plasminogen (Plg) Enzyme-linked immunosorbent assay for Antigen Detection.
USCB236Hu CLIA Kit for Plasminogen (Plg) Chemiluminescent immunoassay for Antigen Detection.
ULMB236Hu Multiplex Assay Kit for Plasminogen (Plg) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
UKSB236Hu01 ELISA Kit DIY Materials for Plasminogen (Plg) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK