CLIA Kit for Factor Related Apoptosis Ligand (FASL)

CD178; CD95L; CD95-L; FASLG; FASLG; APT1LG1; APT1-LG1; TNFSF6; Fas Antigen Ligand; TNF Superfamily Member 6; Tumor Necrosis Factor(ligand)Superfamily,Member 6

  • CLIA Kit for Factor Related Apoptosis Ligand (FASL) Packages (Simulation)
  • CLIA Kit for Factor Related Apoptosis Ligand (FASL) Packages (Simulation)
  • CLIA Kit for Factor Related Apoptosis Ligand (FASL) Results demonstration
  • SCA031Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

This assay has high sensitivity and excellent specificity for detection of Factor Related Apoptosis Ligand (FASL).
No significant cross-reactivity or interference between Factor Related Apoptosis Ligand (FASL) and analogues was observed.

Recovery of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

Matrices listed below were spiked with certain level of recombinant Factor Related Apoptosis Ligand (FASL) and the recovery rates were calculated by comparing the measured value to the expected amount of Factor Related Apoptosis Ligand (FASL) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 90-102 97
EDTA plasma(n=5) 80-99 84
heparin plasma(n=5) 84-99 93

Precision of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Factor Related Apoptosis Ligand (FASL) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Factor Related Apoptosis Ligand (FASL) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Factor Related Apoptosis Ligand (FASL) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-91% 81-91% 84-101% 98-105%
EDTA plasma(n=5) 91-98% 94-102% 96-105% 78-104%
heparin plasma(n=5) 83-95% 80-91% 84-103% 83-96%

Stability of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Factor Related Apoptosis Ligand (FASL)

The microplate provided in this kit has been pre-coated with an antibody specific to Factor Related Apoptosis Ligand (FASL). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Factor Related Apoptosis Ligand (FASL). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Factor Related Apoptosis Ligand (FASL) level in the sample or standard.;

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPA031Mu02 Recombinant Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
EPA031Mu62 Eukaryotic Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
APA031Mu61 Active Factor Related Apoptosis Ligand (FASL) Cell culture; Activity Assays.
EPA031Mu61 Eukaryotic Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
RPA031Mu01 Recombinant Factor Related Apoptosis Ligand (FASL) Positive Control; Immunogen; SDS-PAGE; WB.
PAA031Mu02 Polyclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC; IP.
PAA031Mu01 Polyclonal Antibody to Factor Related Apoptosis Ligand (FASL) WB; IHC; ICC; IP.
SEA031Mu ELISA Kit for Factor Related Apoptosis Ligand (FASL) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA031Mu CLIA Kit for Factor Related Apoptosis Ligand (FASL) Chemiluminescent immunoassay for Antigen Detection.
LMA031Mu Multiplex Assay Kit for Factor Related Apoptosis Ligand (FASL) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA031Mu01 ELISA Kit DIY Materials for Factor Related Apoptosis Ligand (FASL) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK