CLIA Kit for Coagulation Factor X (F10)

FX; FXA; Stuart Prower Factor; Thrombokinase

  • CLIA Kit for Coagulation Factor X (F10) Packages (Simulation)
  • CLIA Kit for Coagulation Factor X (F10) Packages (Simulation)
  • CLIA Kit for Coagulation Factor X (F10) Results demonstration
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Coagulation Factor X (F10)

This assay has high sensitivity and excellent specificity for detection of Coagulation Factor X (F10).
No significant cross-reactivity or interference between Coagulation Factor X (F10) and analogues was observed.

Recovery of the CLIA Kit for Coagulation Factor X (F10)

Matrices listed below were spiked with certain level of recombinant Coagulation Factor X (F10) and the recovery rates were calculated by comparing the measured value to the expected amount of Coagulation Factor X (F10) in samples.

Matrix Recovery range (%) Average(%)
sodium citrate plasma(n=5) 97-105 101

Precision of the CLIA Kit for Coagulation Factor X (F10)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Coagulation Factor X (F10) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Coagulation Factor X (F10) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Coagulation Factor X (F10)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Coagulation Factor X (F10) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
sodium citrate plasma(n=5) 86-105% 96-104% 79-89% 78-88%

Stability of the CLIA Kit for Coagulation Factor X (F10)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Coagulation Factor X (F10)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Coagulation Factor X (F10)

The microplate provided in this kit has been pre-coated with an antibody specific to Coagulation Factor X (F10). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Coagulation Factor X (F10). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Coagulation Factor X (F10) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA834Hu01 Recombinant Coagulation Factor X (F10) Positive Control; Immunogen; SDS-PAGE; WB.
PAA834Hu01 Polyclonal Antibody to Coagulation Factor X (F10) WB; IHC; ICC; IP.
MAA834Hu22 Monoclonal Antibody to Coagulation Factor X (F10) WB; IHC; ICC; IP.
SEA834Hu ELISA Kit for Coagulation Factor X (F10) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA834Hu CLIA Kit for Coagulation Factor X (F10) Chemiluminescent immunoassay for Antigen Detection.
LMA834Hu Multiplex Assay Kit for Coagulation Factor X (F10) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK