Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

BMP8-B; OP2; Osteogenic Protein 2

  • Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B) Packages (Simulation)
  • Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B) Packages (Simulation)
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

This assay has high sensitivity and excellent specificity for detection of Bone Morphogenetic Protein 8B (BMP8B).
No significant cross-reactivity or interference between Bone Morphogenetic Protein 8B (BMP8B) and analogues was observed.

Recovery of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

Matrices listed below were spiked with certain level of recombinant Bone Morphogenetic Protein 8B (BMP8B) and the recovery rates were calculated by comparing the measured value to the expected amount of Bone Morphogenetic Protein 8B (BMP8B) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 96-105 99
EDTA plasma(n=5) 94-103 98
heparin plasma(n=5) 78-105 82
sodium citrate plasma(n=5) 91-105 95

Precision of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Bone Morphogenetic Protein 8B (BMP8B) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Bone Morphogenetic Protein 8B (BMP8B) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Bone Morphogenetic Protein 8B (BMP8B) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 87-95% 95-102% 78-104% 86-96%
EDTA plasma(n=5) 93-104% 96-104% 98-105% 88-102%
heparin plasma(n=5) 89-98% 96-105% 78-93% 97-105%
sodium citrate plasma(n=5) 92-99% 78-98% 78-97% 92-101%

Stability of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

1. Preparation of standards, reagents and samples before the experiment;
2. Add 100μL standard or sample to each well,
    add 10μL magnetic beads, and incubate 90min at 37°C on shaker;
3. Remove liquid on magnetic frame, add 100μL prepared Detection Reagent A. Incubate 60min at 37°C on shaker;
4. Wash plate on magnetic frame for three times;
5. Add 100μL prepared Detection Reagent B, and incubate 30 min at 37°C on shaker;
6. Wash plate on magnetic frame for three times;
7. Add 100μL sheath solution, swirl for 2 minutes, read on the machine.

Test principle of the Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B)

Analyte-specific antibodies are pre-coated onto color-coded microparticles. Microparticles, standards, and samples are pipetted into wells and the immobilized antibodies bind the analytes of interest. After washing away any unbound substances, a biotinylated antibody cocktail specific to the analytes of interest is added to each well. Following a wash to remove any unbound biotinylated antibody, Streptavidin-Phycoerythrin conjugate (Streptavidin-PE), which binds to the biotinylated detection antibodies, is added to each well. A final wash removes unbound Streptavidin-PE and the microparticles are resuspended in buffer and read using the Luminex or Bio-Plex analyzer.The MFI developed is proportional to the concentration of analytes of interest in the sample.

GIVEAWAYS

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPC105Mu01 Recombinant Bone Morphogenetic Protein 8B (BMP8B) Positive Control; Immunogen; SDS-PAGE; WB.
RPC105Mu02 Recombinant Bone Morphogenetic Protein 8B (BMP8B) Positive Control; Immunogen; SDS-PAGE; WB.
PAC105Mu01 Polyclonal Antibody to Bone Morphogenetic Protein 8B (BMP8B) WB; IHC; ICC; IP.
PAC105Mu02 Polyclonal Antibody to Bone Morphogenetic Protein 8B (BMP8B) WB; IHC; ICC; IP.
SEC105Mu ELISA Kit for Bone Morphogenetic Protein 8B (BMP8B) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC105Mu Magnetic Luminex Assay Kit for Bone Morphogenetic Protein 8B (BMP8B) Magnetic Luminex Assay for Antigen Detection.
PGC105Mu01 Primer Pair for Bone Morphogenetic Protein 8B (BMP8B) PCR
GUESTBOOK