ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

CGRP; P6; CAAF1; CAGC; ENRAGE; MRP6; Calgranulin C; Calcium-binding protein in amniotic fluid 1; Extracellular newly identified RAGE-binding; Migration inhibitory factor-related 6

  • ELISA Kit for S100 Calcium Binding Protein A12 (S100A12) Packages (Simulation)
  • ELISA Kit for S100 Calcium Binding Protein A12 (S100A12) Packages (Simulation)
  • ELISA Kit for S100 Calcium Binding Protein A12 (S100A12) Results demonstration
  • SEB080Rb.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

This assay has high sensitivity and excellent specificity for detection of S100 Calcium Binding Protein A12 (S100A12).
No significant cross-reactivity or interference between S100 Calcium Binding Protein A12 (S100A12) and analogues was observed.

Recovery of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

Matrices listed below were spiked with certain level of recombinant S100 Calcium Binding Protein A12 (S100A12) and the recovery rates were calculated by comparing the measured value to the expected amount of S100 Calcium Binding Protein A12 (S100A12) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 79-97 89
EDTA plasma(n=5) 80-103 81
heparin plasma(n=5) 83-96 91

Precision of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level S100 Calcium Binding Protein A12 (S100A12) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level S100 Calcium Binding Protein A12 (S100A12) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of S100 Calcium Binding Protein A12 (S100A12) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 88-101% 85-98% 78-88% 88-101%
EDTA plasma(n=5) 80-94% 88-101% 85-92% 80-102%
heparin plasma(n=5) 81-101% 84-92% 83-104% 91-98%

Stability of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for S100 Calcium Binding Protein A12 (S100A12)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to S100 Calcium Binding Protein A12 (S100A12). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to S100 Calcium Binding Protein A12 (S100A12). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain S100 Calcium Binding Protein A12 (S100A12), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of S100 Calcium Binding Protein A12 (S100A12) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Oryctolagus cuniculus (Rabbit) Applications (RESEARCH USE ONLY!)
RPB080Rb01 Recombinant S100 Calcium Binding Protein A12 (S100A12) Positive Control; Immunogen; SDS-PAGE; WB.
PAB080Rb51 Polyclonal Antibody to S100 Calcium Binding Protein A12 (S100A12) WB; IHC; ICC; IP.
PAB080Rb01 Polyclonal Antibody to S100 Calcium Binding Protein A12 (S100A12) WB; IHC; ICC; IP.
SEB080Rb ELISA Kit for S100 Calcium Binding Protein A12 (S100A12) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB080Rb Multiplex Assay Kit for S100 Calcium Binding Protein A12 (S100A12) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSB080Rb01 ELISA Kit DIY Materials for S100 Calcium Binding Protein A12 (S100A12) Main materials for "Do It(ELISA Kit) Yourself"
GUESTBOOK