ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

CXCL1; GRO1; GROa; GRO-A; MGSA-A; NAP3; SCYB1; Chemokine C-X-C-Motif Ligand 1; Melanoma Growth Stimulating Activity Alpha; Fibroblast Secretory Protein

  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3) Packages (Simulation)
  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3) Packages (Simulation)
  • ELISA Kit for Neutrophil Activating Protein 3 (NAP3) Results demonstration
  • SEA041Ra.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

This assay has high sensitivity and excellent specificity for detection of Neutrophil Activating Protein 3 (NAP3).
No significant cross-reactivity or interference between Neutrophil Activating Protein 3 (NAP3) and analogues was observed.

Recovery of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

Matrices listed below were spiked with certain level of recombinant Neutrophil Activating Protein 3 (NAP3) and the recovery rates were calculated by comparing the measured value to the expected amount of Neutrophil Activating Protein 3 (NAP3) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 92-105 96
EDTA plasma(n=5) 83-97 93
heparin plasma(n=5) 80-96 86

Precision of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Neutrophil Activating Protein 3 (NAP3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Neutrophil Activating Protein 3 (NAP3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Neutrophil Activating Protein 3 (NAP3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 79-93% 84-102% 85-95% 94-101%
EDTA plasma(n=5) 81-89% 89-103% 80-95% 97-105%
heparin plasma(n=5) 80-89% 80-90% 84-101% 80-96%

Stability of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Neutrophil Activating Protein 3 (NAP3)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Neutrophil Activating Protein 3 (NAP3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Neutrophil Activating Protein 3 (NAP3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Neutrophil Activating Protein 3 (NAP3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Neutrophil Activating Protein 3 (NAP3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Rattus norvegicus (Rat) Applications (RESEARCH USE ONLY!)
RPA041Ra01 Recombinant Neutrophil Activating Protein 3 (NAP3) Positive Control; Immunogen; SDS-PAGE; WB.
CPA041Ra11 BSA Conjugated Neutrophil Activating Protein 3 (NAP3) Immunogen; SDS-PAGE; WB.
CPA041Ra21 OVA Conjugated Neutrophil Activating Protein 3 (NAP3) Immunogen; SDS-PAGE; WB.
PAA041Ra01 Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC; IP.
PAA041Ra08 Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC; IP.
LAA041Ra81 FITC-Linked Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC; IF.
LAA041Ra71 Biotin-Linked Polyclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC.
MAA041Ra21 Monoclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC; IP.
MAA041Ra28 Monoclonal Antibody to Neutrophil Activating Protein 3 (NAP3) IHC; ICC; IP.
LAA041Ra72 Biotin-Linked Monoclonal Antibody to Neutrophil Activating Protein 3 (NAP3) WB; IHC; ICC.
SEA041Ra ELISA Kit for Neutrophil Activating Protein 3 (NAP3) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA041Ra CLIA Kit for Neutrophil Activating Protein 3 (NAP3) Chemiluminescent immunoassay for Antigen Detection.
PSA041Ra01 Antibody Pair for Neutrophil Activating Protein 3 (NAP3) ELISA; CLIA; ELISPOT; Luminex; Immunochromatography and other Immunoassays.
KSA041Ra01 ELISA Kit DIY Materials for Neutrophil Activating Protein 3 (NAP3) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK