ELISA Kit for Matrix Metalloproteinase 9 (MMP9)
GELB; Gelatinase B; CLG4B; CLG4-B; 92 KDa Gelatinase; 92kDa Type IV Collagenase
FOR IN VITRO AND RESEARCH USE ONLY, NOT FOR USE IN CLINICAL DIAGNOSTIC PROCEDURES!
- Product No.SEA553Ra
- Organism SpeciesRattus norvegicus (Rat)Same name, Different species.
- Brand OwnerCLOUD-CLONE CORP.(CCC, USA)
- ManufacturerCLOUD-CLONE CORP.(CCC, WUH)
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range4.7-300ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 1.8ng/mL.
- Sample Typeserum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- DownloadInstruction Manual
- FOBUS$ 479US$ 684US$ 3078US$ 5814US$ 47880
- Package and Components
- Package and Components
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
This assay has high sensitivity and excellent specificity for detection of Matrix Metalloproteinase 9 (MMP9).
No significant cross-reactivity or interference between Matrix Metalloproteinase 9 (MMP9) and analogues was observed.
Matrices listed below were spiked with certain level of recombinant Matrix Metalloproteinase 9 (MMP9) and the recovery rates were calculated by comparing the measured value to the expected amount of Matrix Metalloproteinase 9 (MMP9) in samples.
|Matrix||Recovery range (%)||Average(%)|
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Matrix Metalloproteinase 9 (MMP9) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Matrix Metalloproteinase 9 (MMP9) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Matrix Metalloproteinase 9 (MMP9) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Reagents and materials provided
|Pre-coated, ready to use 96-well strip plate||1||Plate sealer for 96 wells||4|
|Detection Reagent A||1×120µL||Assay Diluent A||1×12mL|
|Detection Reagent B||1×120µL||Assay Diluent B||1×12mL|
|TMB Substrate||1×9mL||Stop Solution||1×6mL|
|Wash Buffer (30 × concentrate)||1×20mL||Instruction manual||1|
Assay procedure summary
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Matrix Metalloproteinase 9 (MMP9). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Matrix Metalloproteinase 9 (MMP9). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Matrix Metalloproteinase 9 (MMP9), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Matrix Metalloproteinase 9 (MMP9) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
|Catalog No.||Organism species: Rattus norvegicus (Rat)||Applications|
|EPA553Ra51||Eukaryotic Matrix Metalloproteinase 9 (MMP9)||Positive Control; Immunogen; SDS-PAGE; WB.|
|RPA553Ra01||Recombinant Matrix Metalloproteinase 9 (MMP9)||Positive Control; Immunogen; SDS-PAGE; WB.|
|PAA553Ra07||Polyclonal Antibody to Matrix Metalloproteinase 9 (MMP9)||WB; IHC; ICC; IP.|
|PAA553Ra01||Polyclonal Antibody to Matrix Metalloproteinase 9 (MMP9)||WB; IHC; ICC; IP.|
|LAA553Ra71||Biotin-Linked Polyclonal Antibody to Matrix Metalloproteinase 9 (MMP9)||WB; IHC; ICC.|
|LAA553Ra81||FITC-Linked Polyclonal Antibody to Matrix Metalloproteinase 9 (MMP9)||WB; IHC; ICC; IF.|
|MAA553Ra21||Monoclonal Antibody to Matrix Metalloproteinase 9 (MMP9)||WB; IHC; ICC; IP.|
|SEA553Ra||ELISA Kit for Matrix Metalloproteinase 9 (MMP9)||Enzyme-linked immunosorbent assay for Antigen Detection.|