ELISA Kit for Resistin (RETN)
ADSF; FIZZ3; RETN1; RSTN; XCP1; Adipose tissue-specific secretory factor; C/EBP-epsilon-regulated myeloid-specific secreted cysteine-rich protein; Cysteine-rich secreted FIZZ3
- Product No.SEA847Mu
- Organism SpeciesMus musculus (Mouse) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range0.312-20ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 0.123ng/mL.
- Sample TypeSerum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
For more details, please contact local distributors!US$ 498
For more details, please contact local distributors! US$ 2241
For more details, please contact local distributors! US$ 4233
For more details, please contact local distributors! US$ 34860
For more details, please contact local distributors!
- Packages (Simulation)
- Packages (Simulation)
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Resistin (RETN)
This assay has high sensitivity and excellent specificity for detection of Resistin (RETN).
No significant cross-reactivity or interference between Resistin (RETN) and analogues was observed.
Recovery of the ELISA Kit for Resistin (RETN)
Matrices listed below were spiked with certain level of recombinant Resistin (RETN) and the recovery rates were calculated by comparing the measured value to the expected amount of Resistin (RETN) in samples.
|Matrix||Recovery range (%)||Average(%)|
Precision of the ELISA Kit for Resistin (RETN)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Resistin (RETN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Resistin (RETN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Linearity of the ELISA Kit for Resistin (RETN)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Resistin (RETN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Stability of the ELISA Kit for Resistin (RETN)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Resistin (RETN)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Resistin (RETN)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Resistin (RETN). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Resistin (RETN). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Resistin (RETN), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Resistin (RETN) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
|Catalog No.||Organism species: Mus musculus (Mouse)||Applications (RESEARCH USE ONLY!)|
|RPA847Mu01||Recombinant Resistin (RETN)||Positive Control; Immunogen; SDS-PAGE; WB.|
|RPA847Mu02||Recombinant Resistin (RETN)||Positive Control; Immunogen; SDS-PAGE; WB.|
|PAA847Mu01||Polyclonal Antibody to Resistin (RETN)||WB; IHC; ICC; IP.|
|PAA847Mu02||Polyclonal Antibody to Resistin (RETN)||WB; IHC; ICC; IP.|
|LAA847Mu81||FITC-Linked Polyclonal Antibody to Resistin (RETN)||WB; IHC; ICC; IF.|
|LAA847Mu71||Biotin-Linked Polyclonal Antibody to Resistin (RETN)||WB; IHC; ICC.|
|MAA847Mu21||Monoclonal Antibody to Resistin (RETN)||WB; IHC; ICC; IP.|
|SEA847Mu||ELISA Kit for Resistin (RETN)||Enzyme-linked immunosorbent assay for Antigen Detection.|
|SCA847Mu||CLIA Kit for Resistin (RETN)||Chemiluminescent immunoassay for Antigen Detection.|
|KSA847Mu01||ELISA Kit DIY Materials for Resistin (RETN)||Main materials for "Do It (ELISA Kit) Yourself".|