ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

CD23; FCER2; BLAST-2; CLEC4J; FCE2; IGEBF; C-type lectin domain family 4 member J; Immunoglobulin E-binding factor; Lymphocyte IgE receptor

  • ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Packages (Simulation)
  • ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Packages (Simulation)
  • ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Results demonstration
  • SEB582Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

This assay has high sensitivity and excellent specificity for detection of Receptor II For The Fc Region Of Immunoglobulin E (FceRII).
No significant cross-reactivity or interference between Receptor II For The Fc Region Of Immunoglobulin E (FceRII) and analogues was observed.

Recovery of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

Matrices listed below were spiked with certain level of recombinant Receptor II For The Fc Region Of Immunoglobulin E (FceRII) and the recovery rates were calculated by comparing the measured value to the expected amount of Receptor II For The Fc Region Of Immunoglobulin E (FceRII) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 83-93 89
EDTA plasma(n=5) 83-96 90
heparin plasma(n=5) 89-104 95

Precision of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Receptor II For The Fc Region Of Immunoglobulin E (FceRII) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Receptor II For The Fc Region Of Immunoglobulin E (FceRII) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Receptor II For The Fc Region Of Immunoglobulin E (FceRII) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 94-102% 80-102% 79-95% 89-103%
EDTA plasma(n=5) 83-92% 91-105% 91-105% 79-103%
heparin plasma(n=5) 82-98% 88-104% 96-105% 82-93%

Stability of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Receptor II For The Fc Region Of Immunoglobulin E (FceRII). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Receptor II For The Fc Region Of Immunoglobulin E (FceRII). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Receptor II For The Fc Region Of Immunoglobulin E (FceRII), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Receptor II For The Fc Region Of Immunoglobulin E (FceRII) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB582Hu01 Recombinant Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Positive Control; Immunogen; SDS-PAGE; WB.
APB582Hu01 Active Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Cell culture; Activity Assays.
EPB582Hu61 Eukaryotic Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Positive Control; Immunogen; SDS-PAGE; WB.
PAB582Hu01 Polyclonal Antibody to Receptor II For The Fc Region Of Immunoglobulin E (FceRII) WB; IHC; ICC; IP.
MAB582Hu22 Monoclonal Antibody to Receptor II For The Fc Region Of Immunoglobulin E (FceRII) WB; IHC; ICC; IP.
SEB582Hu ELISA Kit for Receptor II For The Fc Region Of Immunoglobulin E (FceRII) Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK