ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

CCL7; FIC; MARC; NC28; MCP3; SCYA7; Chemokine C-C-Motif Ligand 7; Small Inducible Cytokine A7; Monocyte Chemoattractant Protein 3

  • ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3) Packages (Simulation)
  • ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3) Packages (Simulation)
  • ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3) Results demonstration
  • SEA089Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

This assay has high sensitivity and excellent specificity for detection of Monocyte Chemotactic Protein 3 (MCP3).
No significant cross-reactivity or interference between Monocyte Chemotactic Protein 3 (MCP3) and analogues was observed.

Recovery of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

Matrices listed below were spiked with certain level of recombinant Monocyte Chemotactic Protein 3 (MCP3) and the recovery rates were calculated by comparing the measured value to the expected amount of Monocyte Chemotactic Protein 3 (MCP3) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 90-104 101
EDTA plasma(n=5) 95-102 99
heparin plasma(n=5) 78-97 87

Precision of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Monocyte Chemotactic Protein 3 (MCP3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Monocyte Chemotactic Protein 3 (MCP3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Monocyte Chemotactic Protein 3 (MCP3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 80-88% 97-105% 90-102% 89-97%
EDTA plasma(n=5) 94-105% 90-101% 94-105% 80-101%
heparin plasma(n=5) 88-102% 97-104% 81-102% 99-105%

Stability of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Monocyte Chemotactic Protein 3 (MCP3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Monocyte Chemotactic Protein 3 (MCP3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Monocyte Chemotactic Protein 3 (MCP3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Monocyte Chemotactic Protein 3 (MCP3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
APA089Hu01 Active Monocyte Chemotactic Protein 3 (MCP3) Cell culture; Activity Assays.
RPA089Hu01 Recombinant Monocyte Chemotactic Protein 3 (MCP3) Positive Control; Immunogen; SDS-PAGE; WB.
PAA089Hu01 Polyclonal Antibody to Monocyte Chemotactic Protein 3 (MCP3) WB
MAA089Hu22 Monoclonal Antibody to Monocyte Chemotactic Protein 3 (MCP3) WB; IHC; ICC; IP.
SEA089Hu ELISA Kit for Monocyte Chemotactic Protein 3 (MCP3) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA089Hu CLIA Kit for Monocyte Chemotactic Protein 3 (MCP3) Chemiluminescent immunoassay for Antigen Detection.
LMA089Hu Multiplex Assay Kit for Monocyte Chemotactic Protein 3 (MCP3) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA089Hu01 ELISA Kit DIY Materials for Monocyte Chemotactic Protein 3 (MCP3) Main materials for "Do It(ELISA Kit) Yourself"
GUESTBOOK