ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

CD91; LRP; A2MR; APOER; APR; TGFBR5; Alpha-2-Macroglobulin Receptor; Prolow-density lipoprotein receptor-related protein 1; Apolipoprotein E receptor

  • ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1) Packages (Simulation)
  • ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1) Packages (Simulation)
  • ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1) Results demonstration
  • SEB010Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

This assay has high sensitivity and excellent specificity for detection of Low Density Lipoprotein Receptor Related Protein 1 (LRP1).
No significant cross-reactivity or interference between Low Density Lipoprotein Receptor Related Protein 1 (LRP1) and analogues was observed.

Recovery of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

Matrices listed below were spiked with certain level of recombinant Low Density Lipoprotein Receptor Related Protein 1 (LRP1) and the recovery rates were calculated by comparing the measured value to the expected amount of Low Density Lipoprotein Receptor Related Protein 1 (LRP1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 84-105 94
EDTA plasma(n=5) 92-101 97
heparin plasma(n=5) 90-97 93

Precision of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Low Density Lipoprotein Receptor Related Protein 1 (LRP1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Low Density Lipoprotein Receptor Related Protein 1 (LRP1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Low Density Lipoprotein Receptor Related Protein 1 (LRP1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 92-105% 95-103% 88-95% 96-105%
EDTA plasma(n=5) 80-105% 85-99% 89-98% 89-98%
heparin plasma(n=5) 83-94% 86-99% 97-105% 89-97%

Stability of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Low Density Lipoprotein Receptor Related Protein 1 (LRP1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Low Density Lipoprotein Receptor Related Protein 1 (LRP1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Low Density Lipoprotein Receptor Related Protein 1 (LRP1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Low Density Lipoprotein Receptor Related Protein 1 (LRP1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB010Hu01 Recombinant Low Density Lipoprotein Receptor Related Protein 1 (LRP1) Positive Control; Immunogen; SDS-PAGE; WB.
PAB010Hu01 Polyclonal Antibody to Low Density Lipoprotein Receptor Related Protein 1 (LRP1) WB; IHC; ICC; IP.
MAB010Hu22 Monoclonal Antibody to Low Density Lipoprotein Receptor Related Protein 1 (LRP1) WB; IHC; ICC; IP.
SEB010Hu ELISA Kit for Low Density Lipoprotein Receptor Related Protein 1 (LRP1) Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK