ELISA Kit for Laminin Beta 3 (LAMb3)

LAM-B3; LAMNB1; Nicein subunit beta; Kalinin subunit beta; Epiligrin subunit bata; Laminin B1k chain; Laminin-5 subunit beta

  • ELISA Kit for Laminin Beta 3 (LAMb3) Packages (Simulation)
  • ELISA Kit for Laminin Beta 3 (LAMb3) Packages (Simulation)
  • ELISA Kit for Laminin Beta 3 (LAMb3) Results demonstration
  • SEC081Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Laminin Beta 3 (LAMb3)

This assay has high sensitivity and excellent specificity for detection of Laminin Beta 3 (LAMb3).
No significant cross-reactivity or interference between Laminin Beta 3 (LAMb3) and analogues was observed.

Recovery of the ELISA Kit for Laminin Beta 3 (LAMb3)

Matrices listed below were spiked with certain level of recombinant Laminin Beta 3 (LAMb3) and the recovery rates were calculated by comparing the measured value to the expected amount of Laminin Beta 3 (LAMb3) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 88-98 93
EDTA plasma(n=5) 91-101 95
heparin plasma(n=5) 84-101 96

Precision of the ELISA Kit for Laminin Beta 3 (LAMb3)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Laminin Beta 3 (LAMb3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Laminin Beta 3 (LAMb3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Laminin Beta 3 (LAMb3)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Laminin Beta 3 (LAMb3) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 97-105% 95-105% 82-102% 98-105%
EDTA plasma(n=5) 89-105% 90-104% 79-104% 78-93%
heparin plasma(n=5) 79-94% 86-101% 79-91% 83-96%

Stability of the ELISA Kit for Laminin Beta 3 (LAMb3)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Laminin Beta 3 (LAMb3)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Laminin Beta 3 (LAMb3)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Laminin Beta 3 (LAMb3). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Laminin Beta 3 (LAMb3). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Laminin Beta 3 (LAMb3), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Laminin Beta 3 (LAMb3) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPC081Hu01 Recombinant Laminin Beta 3 (LAMb3) Positive Control; Immunogen; SDS-PAGE; WB.
PAC081Hu01 Polyclonal Antibody to Laminin Beta 3 (LAMb3) WB; IHC
MAC081Hu22 Monoclonal Antibody to Laminin Beta 3 (LAMb3) WB; IHC; ICC; IP.
SEC081Hu ELISA Kit for Laminin Beta 3 (LAMb3) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC081Hu Multiplex Assay Kit for Laminin Beta 3 (LAMb3) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK