ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

CD326; TACSTD1; EGP; KSA; M4S1; MIC18; TROP1; HEGP2; ESA; Epithelial glycoprotein; Adenocarcinoma-associated antigen; Tumor Associated Calcium Signal Transducer 1

  • ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM) Packages (Simulation)
  • ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM) Packages (Simulation)
  • ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM) Results demonstration
  • SEB283Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

This assay has high sensitivity and excellent specificity for detection of Epithelial Cell Adhesion Molecule (EPCAM).
No significant cross-reactivity or interference between Epithelial Cell Adhesion Molecule (EPCAM) and analogues was observed.

Recovery of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

Matrices listed below were spiked with certain level of recombinant Epithelial Cell Adhesion Molecule (EPCAM) and the recovery rates were calculated by comparing the measured value to the expected amount of Epithelial Cell Adhesion Molecule (EPCAM) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 96-104 101
EDTA plasma(n=5) 79-104 91
heparin plasma(n=5) 79-90 86

Precision of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Epithelial Cell Adhesion Molecule (EPCAM) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Epithelial Cell Adhesion Molecule (EPCAM) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Epithelial Cell Adhesion Molecule (EPCAM) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 94-102% 84-101% 96-104% 85-102%
EDTA plasma(n=5) 92-101% 94-105% 83-90% 78-102%
heparin plasma(n=5) 93-102% 83-99% 79-97% 98-105%

Stability of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Epithelial Cell Adhesion Molecule (EPCAM). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Epithelial Cell Adhesion Molecule (EPCAM). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Epithelial Cell Adhesion Molecule (EPCAM), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Epithelial Cell Adhesion Molecule (EPCAM) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB283Hu01 Recombinant Epithelial Cell Adhesion Molecule (EPCAM) Positive Control; Immunogen; SDS-PAGE; WB.
PAB283Hu01 Polyclonal Antibody to Epithelial Cell Adhesion Molecule (EPCAM) WB; IHC; ICC; IP.
MAB283Hu21 Monoclonal Antibody to Epithelial Cell Adhesion Molecule (EPCAM) WB; IHC; ICC; IP.
MAB283Hu22 Monoclonal Antibody to Epithelial Cell Adhesion Molecule (EPCAM) WB; IHC; ICC; IP.
SEB283Hu ELISA Kit for Epithelial Cell Adhesion Molecule (EPCAM) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB283Hu Multiplex Assay Kit for Epithelial Cell Adhesion Molecule (EPCAM) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK