ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

COL3-A1; COL3A1; EDS4A; Collagen Type III Alpha 1; Ehlers-Danlos Syndrome Type IV Autosomal Dominant; Collagen Alpha-1(III)chain

  • ELISA Kit for Collagen Type III Alpha 1 (COL3a1) Packages (Simulation)
  • ELISA Kit for Collagen Type III Alpha 1 (COL3a1) Packages (Simulation)
  • ELISA Kit for Collagen Type III Alpha 1 (COL3a1) Results demonstration
  • SED195Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

This assay has high sensitivity and excellent specificity for detection of Collagen Type III Alpha 1 (COL3a1).
No significant cross-reactivity or interference between Collagen Type III Alpha 1 (COL3a1) and analogues was observed.

Recovery of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

Matrices listed below were spiked with certain level of recombinant Collagen Type III Alpha 1 (COL3a1) and the recovery rates were calculated by comparing the measured value to the expected amount of Collagen Type III Alpha 1 (COL3a1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 78-93 87
EDTA plasma(n=5) 97-105 102
heparin plasma(n=5) 96-105 102

Precision of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Collagen Type III Alpha 1 (COL3a1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Collagen Type III Alpha 1 (COL3a1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Collagen Type III Alpha 1 (COL3a1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 87-102% 86-101% 80-97% 93-105%
EDTA plasma(n=5) 91-105% 95-102% 93-101% 97-105%
heparin plasma(n=5) 80-104% 81-95% 84-93% 87-101%

Stability of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Collagen Type III Alpha 1 (COL3a1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Collagen Type III Alpha 1 (COL3a1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Collagen Type III Alpha 1 (COL3a1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Collagen Type III Alpha 1 (COL3a1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Collagen Type III Alpha 1 (COL3a1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPD195Hu01 Recombinant Collagen Type III Alpha 1 (COL3a1) Positive Control; Immunogen; SDS-PAGE; WB.
PAD195Hu01 Polyclonal Antibody to Collagen Type III Alpha 1 (COL3a1) WB; IHC; ICC; IP.
MAD195Hu21 Monoclonal Antibody to Collagen Type III Alpha 1 (COL3a1) WB; IHC; ICC; IP.
SED195Hu ELISA Kit for Collagen Type III Alpha 1 (COL3a1) Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK