This assay has high sensitivity and excellent specificity for detection of Anti-Insulin Receptor Antibody (Anti-INSR).
No significant cross-reactivity or interference between Anti-Insulin Receptor Antibody (Anti-INSR) and analogues was observed.

Matrices listed below were spiked with certain level of Anti-Insulin Receptor Antibody (Anti-INSR) and the recovery rates were calculated by comparing the measured value to the expected amount of Anti-Insulin Receptor Antibody (Anti-INSR) in samples.

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Anti-Insulin Receptor Antibody (Anti-INSR) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Anti-Insulin Receptor Antibody (Anti-INSR) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Anti-Insulin Receptor Antibody (Anti-INSR) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

The microtiter plate provided in this kit has been pre-coated with an antigen. Standards or samples are then added to the appropriate microtiter plate wells with a Horseradish Peroxidase (HRP)-conjugated secondary antibody. After TMB substrate solution is added, those wells that contain Anti-Insulin Receptor Antibody (Anti-INSR) will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Anti-Insulin Receptor Antibody (Anti-INSR) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

ELISA / CLIA Experiment Service

Single-component Reagents of Assay Kit
Lysis Buffer Specific for ELISA / CLIA
Quality Control of Kit
Disease Model Customized Service
TGFB1 Activation Reagent
Real Time PCR Experimental Service
Single-component Reagents of FLIA Kit