ELISA Kit for Androgen Receptor (AR)

AIS; DHTR; HUMARA; KD; NR3C4; SBMA; SMAX1; TFM; Dihydrotestosterone receptor; Nuclear Receptor Subfamily 3,Group C,Member 4; Testicular Feminization; Kennedy Disease

  • ELISA Kit for Androgen Receptor (AR) Packages (Simulation)
  • ELISA Kit for Androgen Receptor (AR) Packages (Simulation)
  • ELISA Kit for Androgen Receptor (AR) Results demonstration
  • SEB252Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Androgen Receptor (AR)

This assay has high sensitivity and excellent specificity for detection of Androgen Receptor (AR).
No significant cross-reactivity or interference between Androgen Receptor (AR) and analogues was observed.

Precision of the ELISA Kit for Androgen Receptor (AR)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Androgen Receptor (AR) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Androgen Receptor (AR) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability of the ELISA Kit for Androgen Receptor (AR)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Androgen Receptor (AR)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Androgen Receptor (AR)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Androgen Receptor (AR). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Androgen Receptor (AR). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Androgen Receptor (AR), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Androgen Receptor (AR) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPB252Hu03 Recombinant Androgen Receptor (AR) Positive Control; Immunogen; SDS-PAGE; WB.
RPB252Hu01 Recombinant Androgen Receptor (AR) Positive Control; Immunogen; SDS-PAGE; WB.
PAB252Hu02 Polyclonal Antibody to Androgen Receptor (AR) WB; IHC; ICC; IP.
PAB252Hu01 Polyclonal Antibody to Androgen Receptor (AR) WB; IHC; ICC; IP.
LAB252Hu71 Biotin-Linked Polyclonal Antibody to Androgen Receptor (AR) WB; IHC; ICC.
MAB252Hu22 Monoclonal Antibody to Androgen Receptor (AR) WB; IHC; ICC; IP.
SEB252Hu ELISA Kit for Androgen Receptor (AR) Enzyme-linked immunosorbent assay for Antigen Detection.
LMB252Hu Multiplex Assay Kit for Androgen Receptor (AR) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK