ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
- Product No.AEA601Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodIndirect ELISA
- Assay Length2h, 30min
- Detection Range1.56-100ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 0.59ng/mL.
- Sample Typeserum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 560
For more details, please contact local distributors!US$ 800
For more details, please contact local distributors! US$ 3600
For more details, please contact local distributors! US$ 6800
For more details, please contact local distributors! US$ 56000
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
This assay has high sensitivity and excellent specificity for detection of Anti-Myeloperoxidase Antibody (Anti-MPO).
No significant cross-reactivity or interference between Anti-Myeloperoxidase Antibody (Anti-MPO) and analogues was observed.
Recovery of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
Matrices listed below were spiked with certain level of Anti-Myeloperoxidase Antibody (Anti-MPO) and the recovery rates were calculated by comparing the measured value to the expected amount of Anti-Myeloperoxidase Antibody (Anti-MPO) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 87-101 | 92 |
| EDTA plasma(n=5) | 95-102 | 98 |
| heparin plasma(n=5) | 81-98 | 86 |
Precision of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Anti-Myeloperoxidase Antibody (Anti-MPO) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Anti-Myeloperoxidase Antibody (Anti-MPO) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Anti-Myeloperoxidase Antibody (Anti-MPO) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 78-101% | 78-93% | 98-105% | 83-94% |
| EDTA plasma(n=5) | 79-93% | 90-101% | 79-98% | 96-105% |
| heparin plasma(n=5) | 79-90% | 96-103% | 98-105% | 87-94% |
Stability of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 5 times;
5. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
6. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO)
The microtiter plate provided in this kit has been pre-coated with an antigen. Standards or samples are then added to the appropriate microtiter plate wells with a Horseradish Peroxidase (HRP)-conjugated secondary antibody. After TMB substrate solution is added, those wells that contain Anti-Myeloperoxidase Antibody (Anti-MPO) will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Anti-Myeloperoxidase Antibody (Anti-MPO) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Homo sapiens (Human) | Applications (RESEARCH USE ONLY!) |
| RPA601Hu01 | Recombinant Myeloperoxidase (MPO) | Positive Control; Immunogen; SDS-PAGE; WB. |
| EPA601Hu61 | Eukaryotic Myeloperoxidase (MPO) | Positive Control; Immunogen; SDS-PAGE; WB. |
| APA601Hu61 | Active Myeloperoxidase (MPO) | Cell culture; Activity Assays. |
| RPA601Hu02 | Recombinant Myeloperoxidase (MPO) | Positive Control; Immunogen; SDS-PAGE; WB. |
| APA601Hu02 | Active Myeloperoxidase (MPO) | Cell culture; Activity Assays. |
| PAA601Hu01 | Polyclonal Antibody to Myeloperoxidase (MPO) | WB; IHC; ICC; IP. |
| LAA601Hu71 | Biotin-Linked Polyclonal Antibody to Myeloperoxidase (MPO) | WB; IHC; ICC. |
| MAA601Hu23 | Monoclonal Antibody to Myeloperoxidase (MPO) | WB; IHC; ICC; IP. |
| MAA601Hu21 | Monoclonal Antibody to Myeloperoxidase (MPO) | WB; IHC; ICC; IP. |
| MAA601Hu22 | Monoclonal Antibody to Myeloperoxidase (MPO) | WB; IHC; ICC; IP. |
| SEA601Hu | ELISA Kit for Myeloperoxidase (MPO) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| AEA601Hu | ELISA Kit for Anti-Myeloperoxidase Antibody (Anti-MPO) | Enzyme-linked immunosorbent assay for Antibody Detection. |
| SCA601Hu | CLIA Kit for Myeloperoxidase (MPO) | Chemiluminescent immunoassay for Antigen Detection. |
| LMA601Hu | Multiplex Assay Kit for Myeloperoxidase (MPO) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |
| KSA601Hu01 | ELISA Kit DIY Materials for Myeloperoxidase (MPO) | Main materials for "Do It (ELISA Kit) Yourself". |