ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
FBP; FOLR; FR-alpha; MOv18; Adult folate-binding protein; KB cells FBP; Ovarian tumor-associated antigen MOv18
- Product No.AEF460Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodIndirect ELISA
- Assay Length2h, 30min
- Detection Range3.12-200ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 1.25ng/mL.
- Sample Typeserum, plasma and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 630
For more details, please contact local distributors!US$ 900
For more details, please contact local distributors! US$ 4050
For more details, please contact local distributors! US$ 7650
For more details, please contact local distributors! US$ 63000
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
This assay has high sensitivity and excellent specificity for detection of Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1).
No significant cross-reactivity or interference between Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) and analogues was observed.
Recovery of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
Matrices listed below were spiked with certain level of Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) and the recovery rates were calculated by comparing the measured value to the expected amount of Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 99-105 | 102 |
| EDTA plasma(n=5) | 85-101 | 90 |
| heparin plasma(n=5) | 79-96 | 88 |
Precision of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 83-97% | 99-105% | 89-96% | 88-96% |
| EDTA plasma(n=5) | 84-103% | 92-101% | 96-104% | 90-102% |
| heparin plasma(n=5) | 81-89% | 96-105% | 81-99% | 79-92% |
Stability of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 5 times;
5. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
6. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1)
The microtiter plate provided in this kit has been pre-coated with an antigen. Standards or samples are then added to the appropriate microtiter plate wells with a Horseradish Peroxidase (HRP)-conjugated secondary antibody. After TMB substrate solution is added, those wells that contain Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Homo sapiens (Human) | Applications (RESEARCH USE ONLY!) |
| RPF460Hu01 | Recombinant Folate Receptor 1, Adult (FOLR1) | Positive Control; Immunogen; SDS-PAGE; WB. |
| PAF460Hu01 | Polyclonal Antibody to Folate Receptor 1, Adult (FOLR1) | WB,IHC |
| LAF460Hu71 | Biotin-Linked Polyclonal Antibody to Folate Receptor 1, Adult (FOLR1) | WB; IHC; ICC. |
| MAF460Hu21 | Monoclonal Antibody to Folate Receptor 1, Adult (FOLR1) | WB |
| SEF460Hu | ELISA Kit for Folate Receptor 1, Adult (FOLR1) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| AEF460Hu | ELISA Kit for Anti-Folate Receptor 1, Adult Antibody (Anti-FOLR1) | Enzyme-linked immunosorbent assay for Antibody Detection. |
| SCF460Hu | CLIA Kit for Folate Receptor 1, Adult (FOLR1) | Chemiluminescent immunoassay for Antigen Detection. |
| LMF460Hu | Multiplex Assay Kit for Folate Receptor 1, Adult (FOLR1) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |