ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
ANX-A1; ANX1; LPC1; Lipocortin I; Chromobindin-9; Calpactin II; Phospholipase A2 inhibitory protein
- Product No.AEE787Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodIndirect ELISA
- Assay Length2h, 30min
- Detection Range3.12-200ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 1.19ng/mL.
- Sample Typeserum
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 630
For more details, please contact local distributors!US$ 900
For more details, please contact local distributors! US$ 4050
For more details, please contact local distributors! US$ 7650
For more details, please contact local distributors! US$ 63000
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
This assay has high sensitivity and excellent specificity for detection of Anti-Annexin A1 Antibody (Anti-ANXA1).
No significant cross-reactivity or interference between Anti-Annexin A1 Antibody (Anti-ANXA1) and analogues was observed.
Recovery of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
Matrices listed below were spiked with certain level of Anti-Annexin A1 Antibody (Anti-ANXA1) and the recovery rates were calculated by comparing the measured value to the expected amount of Anti-Annexin A1 Antibody (Anti-ANXA1) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 95-104 | 99 |
Precision of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Anti-Annexin A1 Antibody (Anti-ANXA1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Anti-Annexin A1 Antibody (Anti-ANXA1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Anti-Annexin A1 Antibody (Anti-ANXA1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 96-103% | 79-93% | 89-102% | 96-104% |
Stability of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 5 times;
5. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
6. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1)
The microtiter plate provided in this kit has been pre-coated with an antigen. Standards or samples are then added to the appropriate microtiter plate wells with a Horseradish Peroxidase (HRP)-conjugated secondary antibody. After TMB substrate solution is added, those wells that contain Anti-Annexin A1 Antibody (Anti-ANXA1) will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Anti-Annexin A1 Antibody (Anti-ANXA1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Homo sapiens (Human) | Applications (RESEARCH USE ONLY!) |
| APE787Hu01 | Active Annexin A1 (ANXA1) | Cell culture; Activity Assays. |
| RPE787Hu01 | Recombinant Annexin A1 (ANXA1) | Positive Control; Immunogen; SDS-PAGE; WB. |
| PAE787Hu01 | Polyclonal Antibody to Annexin A1 (ANXA1) | WB; IHC; ICC; IP. |
| PAE787Hu02 | Polyclonal Antibody to Annexin A1 (ANXA1) | WB; IHC; ICC; IP. |
| LAE787Hu81 | FITC-Linked Polyclonal Antibody to Annexin A1 (ANXA1) | WB; IHC; ICC; IF. |
| LAE787Hu71 | Biotin-Linked Polyclonal Antibody to Annexin A1 (ANXA1) | WB; IHC; ICC. |
| MAE787Hu22 | Monoclonal Antibody to Annexin A1 (ANXA1) | WB |
| MAE787Hu21 | Monoclonal Antibody to Annexin A1 (ANXA1) | WB; IHC; ICC; IP. |
| SEE787Hu | ELISA Kit for Annexin A1 (ANXA1) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| AEE787Hu | ELISA Kit for Anti-Annexin A1 Antibody (Anti-ANXA1) | Enzyme-linked immunosorbent assay for Antibody Detection. |
| SCE787Hu | CLIA Kit for Annexin A1 (ANXA1) | Chemiluminescent immunoassay for Antigen Detection. |
| LME787Hu | Multiplex Assay Kit for Annexin A1 (ANXA1) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |
| KSE787Hu01 | ELISA Kit DIY Materials for Annexin A1 (ANXA1) | Main materials for "Do It (ELISA Kit) Yourself". |