CLIA Kit for Fibronectin (FN)

FN1; CIG; FINC; LETS; MSF; GFND2; Anastellin; Migration-Stimulating Factor; Cold-Insoluble Globulin; Large, External, Transformation-Sensitive Protein

  • CLIA Kit for Fibronectin (FN) Packages (Simulation)
  • CLIA Kit for Fibronectin (FN) Packages (Simulation)
  • CLIA Kit for Fibronectin (FN) Results demonstration
  • SCA037Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for Fibronectin (FN)

This assay has high sensitivity and excellent specificity for detection of Fibronectin (FN).
No significant cross-reactivity or interference between Fibronectin (FN) and analogues was observed.

Recovery of the CLIA Kit for Fibronectin (FN)

Matrices listed below were spiked with certain level of recombinant Fibronectin (FN) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibronectin (FN) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 82-104 94
EDTA plasma(n=5) 93-103 99
heparin plasma(n=5) 91-98 95

Precision of the CLIA Kit for Fibronectin (FN)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibronectin (FN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibronectin (FN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for Fibronectin (FN)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibronectin (FN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 80-91% 99-105% 80-99% 85-94%
EDTA plasma(n=5) 78-90% 80-91% 85-96% 91-105%
heparin plasma(n=5) 85-101% 98-105% 80-95% 89-103%

Stability of the CLIA Kit for Fibronectin (FN)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for Fibronectin (FN)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for Fibronectin (FN)

The microplate provided in this kit has been pre-coated with an antibody specific to Fibronectin (FN). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Fibronectin (FN). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Fibronectin (FN) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
APA037Hu02 Active Fibronectin (FN) Cell culture; Activity Assays.
RPA037Hu03 Recombinant Fibronectin (FN) Positive Control; Immunogen; SDS-PAGE; WB.
APA037Hu01 Active Fibronectin (FN) Cell culture; Activity Assays.
RPA037Hu01 Recombinant Fibronectin (FN) Positive Control; Immunogen; SDS-PAGE; WB.
RPA037Hu02 Recombinant Fibronectin (FN) Positive Control; Immunogen; SDS-PAGE; WB.
PAA037Hu01 Polyclonal Antibody to Fibronectin (FN) WB; IHC; ICC; IP.
PAA037Hu04 Polyclonal Antibody to Fibronectin (FN) WB; IHC; ICC; IP.
PAA037Hu02 Polyclonal Antibody to Fibronectin (FN) WB; IHC; ICC; IP.
PAA037Hu03 Polyclonal Antibody to Fibronectin (FN) WB; IHC; ICC; IP.
LAA037Hu71 Biotin-Linked Polyclonal Antibody to Fibronectin (FN) WB; IHC; ICC.
MAA037Hu22 Monoclonal Antibody to Fibronectin (FN) WB; IHC; ICC; IP.
SEA037Hu ELISA Kit for Fibronectin (FN) Enzyme-linked immunosorbent assay for Antigen Detection.
HEA037Hu High Sensitive ELISA Kit for Fibronectin (FN) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA037Hu CLIA Kit for Fibronectin (FN) Chemiluminescent immunoassay for Antigen Detection.
KSA037Hu01 ELISA Kit DIY Materials for Fibronectin (FN) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK