High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
INH-bE; Activin beta-E chain
- Product No.HEA048Mu
- Organism SpeciesMus musculus (Mouse) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range1.56-100pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 0.58pg/mL.
- Sample Typeserum, plasma, tissue homogenates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 499
For more details, please contact local distributors!US$ 713
For more details, please contact local distributors! US$ 3209
For more details, please contact local distributors! US$ 6061
For more details, please contact local distributors! US$ 49910
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
This assay has high sensitivity and excellent specificity for detection of High Sensitive Inhibin Beta E (INHbE).
No significant cross-reactivity or interference between High Sensitive Inhibin Beta E (INHbE) and analogues was observed.
Recovery of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
Matrices listed below were spiked with certain level of recombinant High Sensitive Inhibin Beta E (INHbE) and the recovery rates were calculated by comparing the measured value to the expected amount of High Sensitive Inhibin Beta E (INHbE) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 86-103 | 98 |
| EDTA plasma(n=5) | 78-95 | 89 |
| heparin plasma(n=5) | 89-96 | 92 |
Precision of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level High Sensitive Inhibin Beta E (INHbE) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level High Sensitive Inhibin Beta E (INHbE) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of High Sensitive Inhibin Beta E (INHbE) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 89-96% | 94-101% | 93-103% | 78-98% |
| EDTA plasma(n=5) | 82-92% | 92-101% | 80-101% | 78-102% |
| heparin plasma(n=5) | 93-101% | 87-101% | 82-104% | 98-105% |
Stability of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the High Sensitive ELISA Kit for Inhibin Beta E (INHbE)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to High Sensitive Inhibin Beta E (INHbE). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to High Sensitive Inhibin Beta E (INHbE). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain High Sensitive Inhibin Beta E (INHbE), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of High Sensitive Inhibin Beta E (INHbE) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Mus musculus (Mouse) | Applications (RESEARCH USE ONLY!) |
| RPA048Mu01 | Recombinant Inhibin Beta E (INHbE) | Positive Control; Immunogen; SDS-PAGE; WB. |
| RPA048Mu02 | Recombinant Inhibin Beta E (INHbE) | Positive Control; Immunogen; SDS-PAGE; WB. |
| PAA048Mu01 | Polyclonal Antibody to Inhibin Beta E (INHbE) | WB,IHC |
| PAA048Mu02 | Polyclonal Antibody to Inhibin Beta E (INHbE) | WB; IHC; ICC; IP. |
| SEA048Mu | ELISA Kit for Inhibin Beta E (INHbE) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| HEA048Mu | High Sensitive ELISA Kit for Inhibin Beta E (INHbE) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| CEA048Mu | ELISA Kit for Inhibin Beta E (INHbE) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| LMA048Mu | Multiplex Assay Kit for Inhibin Beta E (INHbE) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |