ELISA Kit for Syndecan 1 (SDC1)
CD138; SDC; SYND1; Syndecan Proteoglycan 1
- Product No.SEB966Po
- Organism SpeciesSus scrofa; Porcine (Pig) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range0.156-10ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 0.057ng/mL.
- Sample Typeserum, plasma, tissue homogenates, cell lysates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
For more details, please contact local distributors!US$ 798
For more details, please contact local distributors! US$ 3591
For more details, please contact local distributors! US$ 6783
For more details, please contact local distributors! US$ 55860
For more details, please contact local distributors!
- Packages (Simulation)
- Packages (Simulation)
- Results demonstration
- Typical Standard Curve
- ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Syndecan 1 (SDC1)
This assay has high sensitivity and excellent specificity for detection of Syndecan 1 (SDC1).
No significant cross-reactivity or interference between Syndecan 1 (SDC1) and analogues was observed.
Recovery of the ELISA Kit for Syndecan 1 (SDC1)
Matrices listed below were spiked with certain level of recombinant Syndecan 1 (SDC1) and the recovery rates were calculated by comparing the measured value to the expected amount of Syndecan 1 (SDC1) in samples.
|Matrix||Recovery range (%)||Average(%)|
Precision of the ELISA Kit for Syndecan 1 (SDC1)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Syndecan 1 (SDC1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Syndecan 1 (SDC1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Linearity of the ELISA Kit for Syndecan 1 (SDC1)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Syndecan 1 (SDC1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
Stability of the ELISA Kit for Syndecan 1 (SDC1)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Syndecan 1 (SDC1)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Syndecan 1 (SDC1)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Syndecan 1 (SDC1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Syndecan 1 (SDC1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Syndecan 1 (SDC1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Syndecan 1 (SDC1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
|Catalog No.||Organism species: Sus scrofa; Porcine (Pig)||Applications (RESEARCH USE ONLY!)|
|SEB966Po||ELISA Kit for Syndecan 1 (SDC1)||Enzyme-linked immunosorbent assay for Antigen Detection.|