ELISA Kit for Salusin Beta (SALb)
- Product No.CEC026Ra
- Organism SpeciesRattus norvegicus (Rat) Same name, Different species.
- Test MethodCompetitive Inhibition
- Assay Length2h
- Detection Range4.94-400pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 1.94pg/mL.
- Sample TypeSerum, plasma, tissue homogenates, cell lysates, cell culture supernates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 532
For more details, please contact local distributors!US$ 760
For more details, please contact local distributors! US$ 3420
For more details, please contact local distributors! US$ 6460
For more details, please contact local distributors! US$ 53200
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Salusin Beta (SALb)
This assay has high sensitivity and excellent specificity for detection of Salusin Beta (SALb).
No significant cross-reactivity or interference between Salusin Beta (SALb) and analogues was observed.
Recovery of the ELISA Kit for Salusin Beta (SALb)
Matrices listed below were spiked with certain level of recombinant Salusin Beta (SALb) and the recovery rates were calculated by comparing the measured value to the expected amount of Salusin Beta (SALb) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 87-96 | 90 |
| EDTA plasma(n=5) | 95-103 | 101 |
| heparin plasma(n=5) | 86-101 | 93 |
Precision of the ELISA Kit for Salusin Beta (SALb)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Salusin Beta (SALb) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Salusin Beta (SALb) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Salusin Beta (SALb)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Salusin Beta (SALb) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 90-102% | 90-104% | 97-104% | 88-96% |
| EDTA plasma(n=5) | 80-105% | 86-99% | 89-97% | 79-91% |
| heparin plasma(n=5) | 88-103% | 80-101% | 95-102% | 94-102% |
Stability of the ELISA Kit for Salusin Beta (SALb)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Salusin Beta (SALb)
1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
And then add 50µL prepared Detection Reagent A immediately.
Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.
Test principle of the ELISA Kit for Salusin Beta (SALb)
This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Salusin Beta (SALb) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Salusin Beta (SALb) and unlabeled Salusin Beta (SALb) (Standards or samples) with the pre-coated antibody specific to Salusin Beta (SALb). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Salusin Beta (SALb) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Salusin Beta (SALb) in the sample.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Rattus norvegicus (Rat) | Applications (RESEARCH USE ONLY!) |
| CPC026Ra21 | OVA Conjugated Salusin Beta (SALb) | Immunogen; SDS-PAGE; WB. |
| CEC026Ra | ELISA Kit for Salusin Beta (SALb) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| WEC026Ra | Wide-range ELISA Kit for Salusin Beta (SALb) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| LMC026Ra | Multiplex Assay Kit for Salusin Beta (SALb) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |
| KSC026Ra11 | ELISA Kit DIY Materials for Salusin Beta (SALb) | Main materials for "Do It (ELISA Kit) Yourself". |