ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

SERPINE1; PLANH1; Serpin Peptidase Inhibitor Clade E Member 1; Nexin,Plasminogen Activator Inhibitor Type 1 Serpin E1; Endothelial plasminogen activator inhibitor

  • ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1) Packages (Simulation)
  • ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1) Packages (Simulation)
  • ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1) Results demonstration
  • SEA532Ra.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

This assay has high sensitivity and excellent specificity for detection of Plasminogen Activator Inhibitor 1 (PAI1).
No significant cross-reactivity or interference between Plasminogen Activator Inhibitor 1 (PAI1) and analogues was observed.

Recovery of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

Matrices listed below were spiked with certain level of recombinant Plasminogen Activator Inhibitor 1 (PAI1) and the recovery rates were calculated by comparing the measured value to the expected amount of Plasminogen Activator Inhibitor 1 (PAI1) in samples.

Matrix Recovery range (%) Average(%)
sodium citrate plasma(n=5) 84-102 95

Precision of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Plasminogen Activator Inhibitor 1 (PAI1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
sodium citrate plasma(n=5) 83-93% 79-89% 92-104% 78-96%

Stability of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Plasminogen Activator Inhibitor 1 (PAI1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Plasminogen Activator Inhibitor 1 (PAI1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Plasminogen Activator Inhibitor 1 (PAI1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Plasminogen Activator Inhibitor 1 (PAI1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Rattus norvegicus (Rat) Applications (RESEARCH USE ONLY!)
RPA532Ra01 Recombinant Plasminogen Activator Inhibitor 1 (PAI1) Positive Control; Immunogen; SDS-PAGE; WB.
PAA532Ra01 Polyclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1) WB; IHC; ICC; IP.
MAA532Ra21 Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1) WB; IHC; ICC; IP.
SEA532Ra ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA532Ra CLIA Kit for Plasminogen Activator Inhibitor 1 (PAI1) Chemiluminescent immunoassay for Antigen Detection.
LMA532Ra Multiplex Assay Kit for Plasminogen Activator Inhibitor 1 (PAI1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA532Ra01 ELISA Kit DIY Materials for Plasminogen Activator Inhibitor 1 (PAI1) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK