ELISA Kit for Fibrinogen Degradation Product (FDP)
FnDP; Fibrin Split Products; Fibrin Degradation Product
- Product No.CEA530Rb
- Organism SpeciesOryctolagus cuniculus (Rabbit) Same name, Different species.
- Test MethodCompetitive Inhibition
- Assay Length2h
- Detection Range370.4-30,000ng/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 145.3ng/mL.
- Sample Typeplasma
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 479
For more details, please contact local distributors!US$ 684
For more details, please contact local distributors! US$ 3078
For more details, please contact local distributors! US$ 5814
For more details, please contact local distributors! US$ 47880
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Fibrinogen Degradation Product (FDP)
This assay has high sensitivity and excellent specificity for detection of Fibrinogen Degradation Product (FDP).
No significant cross-reactivity or interference between Fibrinogen Degradation Product (FDP) and analogues was observed.
Recovery of the ELISA Kit for Fibrinogen Degradation Product (FDP)
Matrices listed below were spiked with certain level of recombinant Fibrinogen Degradation Product (FDP) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibrinogen Degradation Product (FDP) in samples.
| Matrix | Recovery range (%) | Average(%) |
| sodium citrate plasma(n=5) | 80-91 | 87 |
Precision of the ELISA Kit for Fibrinogen Degradation Product (FDP)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibrinogen Degradation Product (FDP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibrinogen Degradation Product (FDP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Fibrinogen Degradation Product (FDP)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibrinogen Degradation Product (FDP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| sodium citrate plasma(n=5) | 78-101% | 80-105% | 82-96% | 78-94% |
Stability of the ELISA Kit for Fibrinogen Degradation Product (FDP)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Fibrinogen Degradation Product (FDP)
1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
And then add 50µL prepared Detection Reagent A immediately.
Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.
Test principle of the ELISA Kit for Fibrinogen Degradation Product (FDP)
This assay employs the competitive inhibition enzyme immunoassay technique. A monoclonal antibody specific to Fibrinogen Degradation Product (FDP) has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled Fibrinogen Degradation Product (FDP) and unlabeled Fibrinogen Degradation Product (FDP) (Standards or samples) with the pre-coated antibody specific to Fibrinogen Degradation Product (FDP). After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of Fibrinogen Degradation Product (FDP) in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of Fibrinogen Degradation Product (FDP) in the sample.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Oryctolagus cuniculus (Rabbit) | Applications (RESEARCH USE ONLY!) |
| CEA530Rb | ELISA Kit for Fibrinogen Degradation Product (FDP) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| LMA530Rb | Multiplex Assay Kit for Fibrinogen Degradation Product (FDP) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |