ELISA Kit for Phosphatidylserine (PS)

Ptd-L-Ser; PtdSer

  • ELISA Kit for Phosphatidylserine (PS) Packages (Simulation)
  • ELISA Kit for Phosphatidylserine (PS) Packages (Simulation)
  • ELISA Kit for Phosphatidylserine (PS) Results demonstration
  • CEB881Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Phosphatidylserine (PS)

This assay has high sensitivity and excellent specificity for detection of Phosphatidylserine (PS).
No significant cross-reactivity or interference between Phosphatidylserine (PS) and analogues was observed.

Recovery of the ELISA Kit for Phosphatidylserine (PS)

Matrices listed below were spiked with certain level of recombinant Phosphatidylserine (PS) and the recovery rates were calculated by comparing the measured value to the expected amount of Phosphatidylserine (PS) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 86-98 89
EDTA plasma(n=5) 84-103 97
heparin plasma(n=5) 84-95 90

Precision of the ELISA Kit for Phosphatidylserine (PS)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Phosphatidylserine (PS) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Phosphatidylserine (PS) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Phosphatidylserine (PS)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Phosphatidylserine (PS) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 91-99% 85-97% 95-105% 99-105%
EDTA plasma(n=5) 80-99% 94-102% 90-102% 86-97%
heparin plasma(n=5) 91-105% 78-93% 78-104% 79-101%

Stability of the ELISA Kit for Phosphatidylserine (PS)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Phosphatidylserine (PS)

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.

Test principle of the ELISA Kit for Phosphatidylserine (PS)

This assay employs the competitive inhibition enzyme immunoassay technique. An antibody specific to phosphatidylserine has been pre-coated onto a microplate. A competitive inhibition reaction is launched between biotin labeled phosphatidylserine and unlabeled phosphatidylserine (Standards or samples) with the pre-coated antibody specific to phosphatidylserine. After incubation the unbound conjugate is washed off. Next, avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. The amount of bound HRP conjugate is reverse proportional to the concentration of phosphatidylserine in the sample. After addition of the substrate solution, the intensity of color developed is reverse proportional to the concentration of phosphatidylserine in the sample.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
CEB881Mu ELISA Kit for Phosphatidylserine (PS) Enzyme-linked immunosorbent assay for Antigen Detection.
GUESTBOOK