ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

BRICD3; CHM-I; CHM1; CH-SP; Chondromodulin-1; Chondrosurfactant protein

  • ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1) Packages (Simulation)
  • ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1) Packages (Simulation)
  • ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1) Results demonstration
  • SEC563Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

This assay has high sensitivity and excellent specificity for detection of Leukocyte Cell Derived Chemotaxin 1 (LECT1).
No significant cross-reactivity or interference between Leukocyte Cell Derived Chemotaxin 1 (LECT1) and analogues was observed.

Recovery of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

Matrices listed below were spiked with certain level of recombinant Leukocyte Cell Derived Chemotaxin 1 (LECT1) and the recovery rates were calculated by comparing the measured value to the expected amount of Leukocyte Cell Derived Chemotaxin 1 (LECT1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 80-103 88
EDTA plasma(n=5) 87-95 91
heparin plasma(n=5) 90-105 95

Precision of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Leukocyte Cell Derived Chemotaxin 1 (LECT1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Leukocyte Cell Derived Chemotaxin 1 (LECT1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Leukocyte Cell Derived Chemotaxin 1 (LECT1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 81-99% 81-96% 86-98% 96-104%
EDTA plasma(n=5) 85-99% 81-91% 97-104% 82-94%
heparin plasma(n=5) 97-105% 93-102% 84-103% 79-104%

Stability of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Leukocyte Cell Derived Chemotaxin 1 (LECT1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Leukocyte Cell Derived Chemotaxin 1 (LECT1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Leukocyte Cell Derived Chemotaxin 1 (LECT1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Leukocyte Cell Derived Chemotaxin 1 (LECT1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPC563Mu01 Recombinant Leukocyte Cell Derived Chemotaxin 1 (LECT1) Positive Control; Immunogen; SDS-PAGE; WB.
RPC563Mu02 Recombinant Leukocyte Cell Derived Chemotaxin 1 (LECT1) Positive Control; Immunogen; SDS-PAGE; WB.
PAC563Mu02 Polyclonal Antibody to Leukocyte Cell Derived Chemotaxin 1 (LECT1) WB; IHC; ICC; IP.
PAC563Mu01 Polyclonal Antibody to Leukocyte Cell Derived Chemotaxin 1 (LECT1) WB; IHC; ICC; IP.
SEC563Mu ELISA Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC563Mu Multiplex Assay Kit for Leukocyte Cell Derived Chemotaxin 1 (LECT1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK