ELISA Kit for Insulin Receptor (INSR)

CD220; ISR; HHF5; IR

  • ELISA Kit for Insulin Receptor (INSR) Packages (Simulation)
  • ELISA Kit for Insulin Receptor (INSR) Packages (Simulation)
  • ELISA Kit for Insulin Receptor (INSR) Results demonstration
  • SEA895Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Insulin Receptor (INSR)

This assay has high sensitivity and excellent specificity for detection of Insulin Receptor (INSR).
No significant cross-reactivity or interference between Insulin Receptor (INSR) and analogues was observed.

Recovery of the ELISA Kit for Insulin Receptor (INSR)

Matrices listed below were spiked with certain level of recombinant Insulin Receptor (INSR) and the recovery rates were calculated by comparing the measured value to the expected amount of Insulin Receptor (INSR) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 99-105 102
EDTA plasma(n=5) 92-99 96
heparin plasma(n=5) 81-98 93

Precision of the ELISA Kit for Insulin Receptor (INSR)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Insulin Receptor (INSR) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Insulin Receptor (INSR) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Insulin Receptor (INSR)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Insulin Receptor (INSR) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 79-101% 89-104% 84-98% 92-102%
EDTA plasma(n=5) 80-93% 82-96% 84-96% 84-99%
heparin plasma(n=5) 81-89% 81-95% 97-105% 86-94%

Stability of the ELISA Kit for Insulin Receptor (INSR)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Insulin Receptor (INSR)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Insulin Receptor (INSR)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Insulin Receptor (INSR). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Insulin Receptor (INSR). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Insulin Receptor (INSR), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Insulin Receptor (INSR) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPA895Mu01 Recombinant Insulin Receptor (INSR) Positive Control; Immunogen; SDS-PAGE; WB.
PAA895Mu02 Polyclonal Antibody to Insulin Receptor (INSR) WB; IHC; ICC; IP.
PAA895Mu01 Polyclonal Antibody to Insulin Receptor (INSR) WB; IHC; ICC; IP.
LAA895Mu81 FITC-Linked Polyclonal Antibody to Insulin Receptor (INSR) WB; IHC; ICC; IF.
SEA895Mu ELISA Kit for Insulin Receptor (INSR) Enzyme-linked immunosorbent assay for Antigen Detection.
MEA895Mu Mini Samples ELISA Kit for Insulin Receptor (INSR) Enzyme-linked immunosorbent assay for Antigen Detection.
LMA895Mu Multiplex Assay Kit for Insulin Receptor (INSR) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK