ELISA Kit for Inhibin Alpha (INHa)

INH-A

  • ELISA Kit for Inhibin Alpha (INHa) Packages (Simulation)
  • ELISA Kit for Inhibin Alpha (INHa) Packages (Simulation)
  • ELISA Kit for Inhibin Alpha (INHa) Results demonstration
  • SEA395Mu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Inhibin Alpha (INHa)

This assay has high sensitivity and excellent specificity for detection of Inhibin Alpha (INHa).
No significant cross-reactivity or interference between Inhibin Alpha (INHa) and analogues was observed.

Recovery of the ELISA Kit for Inhibin Alpha (INHa)

Matrices listed below were spiked with certain level of recombinant Inhibin Alpha (INHa) and the recovery rates were calculated by comparing the measured value to the expected amount of Inhibin Alpha (INHa) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 97-104 101
EDTA plasma(n=5) 80-103 98
heparin plasma(n=5) 80-91 85

Precision of the ELISA Kit for Inhibin Alpha (INHa)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Inhibin Alpha (INHa) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Inhibin Alpha (INHa) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Inhibin Alpha (INHa)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Inhibin Alpha (INHa) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 97-105% 85-92% 90-101% 91-99%
EDTA plasma(n=5) 80-97% 96-105% 85-97% 87-95%
heparin plasma(n=5) 98-105% 90-98% 80-105% 96-105%

Stability of the ELISA Kit for Inhibin Alpha (INHa)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Inhibin Alpha (INHa)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Inhibin Alpha (INHa)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Inhibin Alpha (INHa). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Inhibin Alpha (INHa). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Inhibin Alpha (INHa), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Inhibin Alpha (INHa) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Mus musculus (Mouse) Applications (RESEARCH USE ONLY!)
RPA395Mu01 Recombinant Inhibin Alpha (INHa) Positive Control; Immunogen; SDS-PAGE; WB.
RPA395Mu02 Recombinant Inhibin Alpha (INHa) Positive Control; Immunogen; SDS-PAGE; WB.
PAA395Mu01 Polyclonal Antibody to Inhibin Alpha (INHa) WB; IHC; ICC; IP.
PAA395Mu02 Polyclonal Antibody to Inhibin Alpha (INHa) WB; IHC; ICC; IP.
SEA395Mu ELISA Kit for Inhibin Alpha (INHa) Enzyme-linked immunosorbent assay for Antigen Detection.
CEA395Mu ELISA Kit for Inhibin Alpha (INHa) Enzyme-linked immunosorbent assay for Antigen Detection.
CCA395Mu CLIA Kit for Inhibin Alpha (INHa) Chemiluminescent immunoassay for Antigen Detection.
LMA395Mu Multiplex Assay Kit for Inhibin Alpha (INHa) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
KSA395Mu11 ELISA Kit DIY Materials for Inhibin Alpha (INHa) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK