ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
P3CP; C-Propeptide Of Type III Procollagen; Procollagen III Carboxy Terminal Propeptide
- Product No.SEA963Hu
- Organism SpeciesHomo sapiens (Human) Same name, Different species.
- Test MethodDouble-antibody Sandwich
- Assay Length3h
- Detection Range15.6-1,000pg/mL
- SensitivityThe minimum detectable dose of this kit is typically less than 6.7pg/mL.
- Sample TypeSerum, plasma, tissue homogenates and other biological fluids
- Download Instruction Manual
- UOM 48T96T 96T*5 96T*10 96T*100
-
FOB
US$ 441
For more details, please contact local distributors!US$ 630
For more details, please contact local distributors! US$ 2835
For more details, please contact local distributors! US$ 5355
For more details, please contact local distributors! US$ 44100
For more details, please contact local distributors!
-
Packages (Simulation)
-
Packages (Simulation)
-
Results demonstration
-
Typical Standard Curve
-
ISO9001: 2008, ISO13485: 2003 Registered
Specificity of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
This assay has high sensitivity and excellent specificity for detection of Procollagen III C-Terminal Propeptide (PIIICP).
No significant cross-reactivity or interference between Procollagen III C-Terminal Propeptide (PIIICP) and analogues was observed.
Recovery of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
Matrices listed below were spiked with certain level of recombinant Procollagen III C-Terminal Propeptide (PIIICP) and the recovery rates were calculated by comparing the measured value to the expected amount of Procollagen III C-Terminal Propeptide (PIIICP) in samples.
| Matrix | Recovery range (%) | Average(%) |
| serum(n=5) | 95-103 | 101 |
| EDTA plasma(n=5) | 90-97 | 93 |
| heparin plasma(n=5) | 88-105 | 101 |
Precision of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Procollagen III C-Terminal Propeptide (PIIICP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Procollagen III C-Terminal Propeptide (PIIICP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%
Linearity of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Procollagen III C-Terminal Propeptide (PIIICP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.
| Sample | 1:2 | 1:4 | 1:8 | 1:16 |
| serum(n=5) | 80-102% | 94-102% | 93-101% | 89-103% |
| EDTA plasma(n=5) | 98-105% | 95-104% | 83-97% | 97-105% |
| heparin plasma(n=5) | 80-95% | 88-104% | 78-98% | 90-104% |
Stability of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
Assay procedure summary of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.
Test principle of the ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP)
The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Procollagen III C-Terminal Propeptide (PIIICP). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Procollagen III C-Terminal Propeptide (PIIICP). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Procollagen III C-Terminal Propeptide (PIIICP), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Procollagen III C-Terminal Propeptide (PIIICP) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
GIVEAWAYS
INCREMENT SERVICES
Related products
| Catalog No. | Organism species: Homo sapiens (Human) | Applications (RESEARCH USE ONLY!) |
| RPA963Hu01 | Recombinant Procollagen III C-Terminal Propeptide (PIIICP) | Positive Control; Immunogen; SDS-PAGE; WB. |
| SEA963Hu | ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| CEA963Hu | ELISA Kit for Procollagen III C-Terminal Propeptide (PIIICP) | Enzyme-linked immunosorbent assay for Antigen Detection. |
| LMA963Hu | Multiplex Assay Kit for Procollagen III C-Terminal Propeptide (PIIICP) ,etc. by FLIA (Flow Luminescence Immunoassay) | FLIA Kit for Antigen Detection. |