ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

TN; TNA; Tetranectin; Plasminogen Binding Protein; Plasminogen kringle 4-binding protein

  • ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B) Packages (Simulation)
  • ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B) Packages (Simulation)
  • ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B) Results demonstration
  • SEL350Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

This assay has high sensitivity and excellent specificity for detection of C-Type Lectin Domain Family 3, Member B (CLEC3B).
No significant cross-reactivity or interference between C-Type Lectin Domain Family 3, Member B (CLEC3B) and analogues was observed.

Recovery of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

Matrices listed below were spiked with certain level of recombinant C-Type Lectin Domain Family 3, Member B (CLEC3B) and the recovery rates were calculated by comparing the measured value to the expected amount of C-Type Lectin Domain Family 3, Member B (CLEC3B) in samples.

Matrix Recovery range (%) Average(%)
sodium citrate plasma(n=5) 90-105 99

Precision of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level C-Type Lectin Domain Family 3, Member B (CLEC3B) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level C-Type Lectin Domain Family 3, Member B (CLEC3B) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of C-Type Lectin Domain Family 3, Member B (CLEC3B) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
sodium citrate plasma(n=5) 90-102% 94-102% 80-97% 96-104%

Stability of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to C-Type Lectin Domain Family 3, Member B (CLEC3B). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to C-Type Lectin Domain Family 3, Member B (CLEC3B). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain C-Type Lectin Domain Family 3, Member B (CLEC3B), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of C-Type Lectin Domain Family 3, Member B (CLEC3B) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
APL350Hu01 Active C-Type Lectin Domain Family 3, Member B (CLEC3B) Cell culture; Activity Assays.
RPL350Hu01 Recombinant C-Type Lectin Domain Family 3, Member B (CLEC3B) Positive Control; Immunogen; SDS-PAGE; WB.
PAL350Hu01 Polyclonal Antibody to C-Type Lectin Domain Family 3, Member B (CLEC3B) WB; IHC; ICC; IP.
MAL350Hu21 Monoclonal Antibody to C-Type Lectin Domain Family 3, Member B (CLEC3B) WB; IHC; ICC; IP.
SEL350Hu ELISA Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B) Enzyme-linked immunosorbent assay for Antigen Detection.
LML350Hu Multiplex Assay Kit for C-Type Lectin Domain Family 3, Member B (CLEC3B) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK