ELISA Kit for Fibulin 1 (FBLN1)

  • ELISA Kit for Fibulin 1 (FBLN1) Packages (Simulation)
  • ELISA Kit for Fibulin 1 (FBLN1) Packages (Simulation)
  • ELISA Kit for Fibulin 1 (FBLN1) Results demonstration
  • SEC472Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Fibulin 1 (FBLN1)

This assay has high sensitivity and excellent specificity for detection of Fibulin 1 (FBLN1).
No significant cross-reactivity or interference between Fibulin 1 (FBLN1) and analogues was observed.

Recovery of the ELISA Kit for Fibulin 1 (FBLN1)

Matrices listed below were spiked with certain level of recombinant Fibulin 1 (FBLN1) and the recovery rates were calculated by comparing the measured value to the expected amount of Fibulin 1 (FBLN1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 84-101 90
EDTA plasma(n=5) 86-95 90
heparin plasma(n=5) 97-105 101

Precision of the ELISA Kit for Fibulin 1 (FBLN1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Fibulin 1 (FBLN1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Fibulin 1 (FBLN1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Fibulin 1 (FBLN1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Fibulin 1 (FBLN1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 80-91% 95-103% 95-104% 79-105%
EDTA plasma(n=5) 84-96% 98-105% 99-105% 80-92%
heparin plasma(n=5) 88-96% 86-101% 95-103% 82-101%

Stability of the ELISA Kit for Fibulin 1 (FBLN1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Fibulin 1 (FBLN1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Fibulin 1 (FBLN1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Fibulin 1 (FBLN1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Fibulin 1 (FBLN1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Fibulin 1 (FBLN1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Fibulin 1 (FBLN1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPC472Hu02 Recombinant Fibulin 1 (FBLN1) Positive Control; Immunogen; SDS-PAGE; WB.
RPC472Hu03 Recombinant Fibulin 1 (FBLN1) Positive Control; Immunogen; SDS-PAGE; WB.
RPC472Hu01 Recombinant Fibulin 1 (FBLN1) Positive Control; Immunogen; SDS-PAGE; WB.
PAC472Hu02 Polyclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC; IP.
PAC472Hu01 Polyclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC; IP.
PAC472Hu03 Polyclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC; IP.
LAC472Hu71 Biotin-Linked Polyclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC.
MAC472Hu21 Monoclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC; IP.
MAC472Hu22 Monoclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC; IP.
LAC472Hu72 Biotin-Linked Monoclonal Antibody to Fibulin 1 (FBLN1) WB; IHC; ICC.
SEC472Hu ELISA Kit for Fibulin 1 (FBLN1) Enzyme-linked immunosorbent assay for Antigen Detection.
SCC472Hu CLIA Kit for Fibulin 1 (FBLN1) Chemiluminescent immunoassay for Antigen Detection.
LMC472Hu Multiplex Assay Kit for Fibulin 1 (FBLN1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
PSC472Hu01 Antibody Pair for Fibulin 1 (FBLN1) ELISA; CLIA; ELISPOT; Luminex; Immunochromatography and other Immunoassays.
KSC472Hu01 ELISA Kit DIY Materials for Fibulin 1 (FBLN1) Main materials for "Do It (ELISA Kit) Yourself".
GUESTBOOK