CLIA Kit for P-Selectin (SELP)

CD62P; Selectin, Platelet; PSEL; GMP140; LECAM3; GRMP; GMRP; PADGEM; Leukocyte-endothelial cell adhesion molecule 3; Platelet activation dependent granule-external membrane

  • CLIA Kit for P-Selectin (SELP) Packages (Simulation)
  • CLIA Kit for P-Selectin (SELP) Packages (Simulation)
  • CLIA Kit for P-Selectin (SELP) Results demonstration
  • SCA569Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the CLIA Kit for P-Selectin (SELP)

This assay has high sensitivity and excellent specificity for detection of P-Selectin (SELP).
No significant cross-reactivity or interference between P-Selectin (SELP) and analogues was observed.

Recovery of the CLIA Kit for P-Selectin (SELP)

Matrices listed below were spiked with certain level of recombinant P-Selectin (SELP) and the recovery rates were calculated by comparing the measured value to the expected amount of P-Selectin (SELP) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 89-102 94
EDTA plasma(n=5) 78-93 89
heparin plasma(n=5) 80-99 89

Precision of the CLIA Kit for P-Selectin (SELP)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level P-Selectin (SELP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level P-Selectin (SELP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the CLIA Kit for P-Selectin (SELP)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of P-Selectin (SELP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 82-101% 79-93% 95-104% 92-101%
EDTA plasma(n=5) 95-104% 98-105% 78-104% 96-105%
heparin plasma(n=5) 98-105% 96-104% 97-105% 88-95%

Stability of the CLIA Kit for P-Selectin (SELP)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the CLIA Kit for P-Selectin (SELP)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 100µL Substrate Solution. Incubate 10 minutes at 37°C;
8. Read RLU value immediately.

Test principle of the CLIA Kit for P-Selectin (SELP)

The microplate provided in this kit has been pre-coated with an antibody specific to P-Selectin (SELP). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to P-Selectin (SELP). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the P-Selectin (SELP) level in the sample or standard.;

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPA569Hu02 Recombinant P-Selectin (SELP) Positive Control; Immunogen; SDS-PAGE; WB.
EPA569Hu61 Eukaryotic P-Selectin (SELP) Positive Control; Immunogen; SDS-PAGE; WB.
APA569Hu61 Active P-Selectin (SELP) Cell culture; Activity Assays.
RPA569Hu01 Recombinant P-Selectin (SELP) Positive Control; Immunogen; SDS-PAGE; WB.
PAA569Hu01 Polyclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
PAA569Hu02 Polyclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
LAA569Hu71 Biotin-Linked Polyclonal Antibody to P-Selectin (SELP) WB; IHC; ICC.
LAA569Hu81 FITC-Linked Polyclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IF.
MAA569Hu24 Monoclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
MAA569Hu21 Monoclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
MAA569Hu22 Monoclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
MAA569Hu23 Monoclonal Antibody to P-Selectin (SELP) WB; IHC; ICC; IP.
SEA569Hu ELISA Kit for P-Selectin (SELP) Enzyme-linked immunosorbent assay for Antigen Detection.
SCA569Hu CLIA Kit for P-Selectin (SELP) Chemiluminescent immunoassay for Antigen Detection.
LMA569Hu Multiplex Assay Kit for P-Selectin (SELP) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK